powered by

Install First Tread and Riser

From How to Cover Waterfall-Style Stairs with Treads · Step 6 of 9 · Video by MatthiasWandel

Showing 2:32–3:28 of the source video. Watch the full video with every moment.

What happens in this clip

Start installing from the bottom step. Apply construction adhesive generously to the existing stair tread. Place the first new stair tread securely on top of the existing tread. Then, apply a bead of construction adhesive along the top back edge of the newly installed tread and along the front edge of the existing step. Insert a small scrap wedge of wood behind the bottom edge of the new riser to provide additional support, ensuring it resists kicks. Apply construction adhesive to the back of the bevel-cut riser and secure it in place with a nail gun. Use finishing nails spaced evenly along the top and bottom edges. The construction adhesive provides the primary bond, while the nails hold the pieces in place until the adhesive cures.

Goal: Securely attach the first new stair tread and riser

What's used

Tools

  • Caulk Gun
  • Nail Gun Porter-Cable
  • Brad nailer

Materials

  • Bevel Cut Riser
  • modified for fit.
  • Construction Adhesive PL (Polyurethane)
  • Gorilla Glue Construction Adhesive
  • Finishing Nails
  • New Stair Tread
  • Scrap Wood Wedge

About the full video

This project provides a detailed guide on how to install pre-fabricated stair treads and risers onto an existing wooden staircase. The process involves precise measurement, cutting, and custom fitting of the risers to accommodate the new treads, followed by securing them with construction adhesive and a nail gun. The aim is to upgrade the appearance of a staircase by covering existing unfinished steps with new, decorative wood pieces.

Step 6 of 9: Apply Adhesive and Fasteners

Apply a generous bead of high-quality construction adhesive to the back of each new tread. Spread the adhesive evenly, ensuring good coverage, especially along the edges and towards the nosing. For waterfall treads, ensure adhesive is applied to the entire surface that will contact the existing tread. Immediately after applying adhesive, position the tread onto the existing stair. For added security, pre-drill pilot holes through the new tread into the existing tread below, and then drive screws or finish nails. Ensure fasteners are countersunk slightly below the surface for a clean finish. For waterfall edges, consider using specialized brackets or reinforcing blocks if required by the design or for structural integrity.

Open this step in the guide

Every video in How to Cover Waterfall-Style Stairs with Treads

  1. Step 1: Inspect Existing Treads and Risers

  2. Step 2: Measure and Template for New Treads

  3. Step 3: Cut New Treads

  4. Step 4: Prepare Existing Surfaces

  5. Step 5: Dry Fit New Treads

  6. Step 6: Apply Adhesive and Fasteners

  7. Step 7: Install Waterfall Risers/Returns (if applicable)

  8. Step 8: Fill and Sand Fastener Holes

  9. Step 9: Apply Finish to Treads

How to Cover Waterfall-Style Stairs with Treads

This project outlines the process of covering waterfall-style stairs with new treads. Waterfall stairs have treads that extend beyond the riser, creating an open side. This project focuses on installing new treads over existing ones, potentially for aesthetic updates or to repair worn surfaces.

Read the full guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Install First Tread and Riser — How to Cover Waterfall-Style Stairs with Treads | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.