Mount Switch and Install Faceplate
From How to Install a Motion-Sensor Light Switch in a Stairway · Step 7 of 8 · Video by Astro Crescent

Showing 4:51–5:25 of the source video. Watch the full video with every moment.
What happens in this clip
Once the wiring is complete and neatly tucked into the electrical box, mount the new motion sensor switch using the existing, longer screws that were previously removed. Point out the small tab on the side of the switch that is used for advanced programming. For this installation, the switch will be left in its default settings, and programming details will be covered in a separate video. Finally, install the cover plate, securing it with the appropriate screws.
Goal: Secure the new motion sensor switch and its cover plate to the electrical box.
What's used
Tools
- Existing Screws Unspecified
- Screwdriver Unspecified
About the full video
This DIY project demonstrates how to replace a standard single-pole light switch with a Lutron Occupancy Motion Sensor Light Switch. The process covers essential safety steps, removal of the old switch, understanding the new switch's wiring, making proper electrical connections, mounting the new device, and testing its basic functionality.
Step 7 of 8: Install the Cover Plate
Place the new cover plate over the motion sensor switch, aligning the screw holes. Secure the cover plate using the provided screws. Ensure the plate is flush with the wall surface.
Every video in How to Install a Motion-Sensor Light Switch in a Stairway
Step 1: Turn Off Power
- 0:37–0:52 Cut Power at Circuit Breaker
- 0:51–0:57 Turn off Power at Breaker
- 0:49–0:55 Disconnect Power
Step 2: Remove Existing Switch Plate and Switch
- 27:53–28:00 Remove Existing Switch Plate and Switch
- 0:25–0:34 Remove Existing Light Switch
- 1:46–2:24 Remove Existing Switch and Cover
Step 3: Identify and Disconnect Wires
- 0:05–0:24 Identify and Disconnect Wires
- 2:44–4:10 Disconnect Old Switch & Identify Wires
- 0:47–1:01 Disconnect the Wires Connected to the Outlet Switch
Step 4: Connect Motion Sensor Switch - Line and Load
- 0:34–0:47 Wire the New Motion Sensor Switch
- 5:45–6:30 Wire the Motion Sensor Switch
- 0:05–0:11 Wire New Motion Sensor Switch
Step 5: Connect Ground Wire
- 3:28–3:58 Connect Ground Wires
- 0:52–0:58 Connect the Ground Wire
- 0:59–1:07 Connect Ground Wire to New Switch
Step 6: Mount the Motion Sensor Switch
- 0:11–0:12 Mount Motion Sensor Switch
- 0:47–0:55 Mount Switch and Attach Faceplate
- 2:41–3:07 Mount Switch and Adjust Settings
Step 7: Install the Cover Plate
- 7:43–7:51 Install Wall Plate
- 3:07–3:55 Install Cover Plate and Final Test
- 4:51–5:25 Mount Switch and Install Faceplate (this video)
Step 8: Restore Power and Test
- 2:14–2:58 Restore Power and Test Functionality
- 3:16–4:29 Restore Power and Test Functionality
- 5:30–5:53 Test Switch Operation
How to Install a Motion-Sensor Light Switch in a Stairway
This project outlines the steps for installing a motion sensor light switch to automate lighting in a stairway. It covers preparation, wiring, mounting, and testing the new switch.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

