Install Cover Plate and Final Test
From How to Install a Motion-Sensor Light Switch in a Stairway · Step 7 of 8 · Video by Kevin Jones

Showing 3:07–3:55 of the source video. Watch the full video with every moment.
What happens in this clip
The final step involves installing the decorative switch plate cover over the newly installed motion sensor switch. This provides a finished look and covers the wiring. After the cover is in place, the light's operation is tested again to confirm that the motion sensor is functioning correctly and the light turns on and off as expected based on the set sensitivity and timer. The video shows the light turning off after a set period, demonstrating the successful installation and operation of the motion sensor switch.
Goal: Complete the installation and verify proper functioning of the motion sensor light switch.
What's used
Tools
- Screwdriver
- Switch Plate Cover
About the full video
This instructional video provides a step-by-step guide on how to safely replace a standard light switch with a motion sensor light switch using existing wiring. The process includes verifying power, identifying wires, connecting the new switch, securing it, and making final adjustments to its settings, emphasizing safety throughout.
Step 7 of 8: Install the Cover Plate
Place the new cover plate over the motion sensor switch, aligning the screw holes. Secure the cover plate using the provided screws. Ensure the plate is flush with the wall surface.
Every video in How to Install a Motion-Sensor Light Switch in a Stairway
Step 1: Turn Off Power
- 0:37–0:52 Cut Power at Circuit Breaker
- 0:51–0:57 Turn off Power at Breaker
- 0:49–0:55 Disconnect Power
Step 2: Remove Existing Switch Plate and Switch
- 27:53–28:00 Remove Existing Switch Plate and Switch
- 0:25–0:34 Remove Existing Light Switch
- 1:46–2:24 Remove Existing Switch and Cover
Step 3: Identify and Disconnect Wires
- 0:05–0:24 Identify and Disconnect Wires
- 2:44–4:10 Disconnect Old Switch & Identify Wires
- 0:47–1:01 Disconnect the Wires Connected to the Outlet Switch
Step 4: Connect Motion Sensor Switch - Line and Load
- 0:34–0:47 Wire the New Motion Sensor Switch
- 5:45–6:30 Wire the Motion Sensor Switch
- 0:05–0:11 Wire New Motion Sensor Switch
Step 5: Connect Ground Wire
- 3:28–3:58 Connect Ground Wires
- 0:52–0:58 Connect the Ground Wire
- 0:59–1:07 Connect Ground Wire to New Switch
Step 6: Mount the Motion Sensor Switch
- 0:11–0:12 Mount Motion Sensor Switch
- 0:47–0:55 Mount Switch and Attach Faceplate
- 2:41–3:07 Mount Switch and Adjust Settings
Step 7: Install the Cover Plate
- 7:43–7:51 Install Wall Plate
- 3:07–3:55 Install Cover Plate and Final Test (this video)
- 4:51–5:25 Mount Switch and Install Faceplate
Step 8: Restore Power and Test
- 2:14–2:58 Restore Power and Test Functionality
- 3:16–4:29 Restore Power and Test Functionality
- 5:30–5:53 Test Switch Operation
How to Install a Motion-Sensor Light Switch in a Stairway
This project outlines the steps for installing a motion sensor light switch to automate lighting in a stairway. It covers preparation, wiring, mounting, and testing the new switch.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

