powered by

How to Install the Lutron Maestro Motion Sensor Light Switch

Video by Astro Crescent · 2 moments used in Oak Valley Designs's DIY guides · 6:27 long

Moments in this video

  1. 4:51–5:25 Mount Switch and Install Faceplate From How to Install a Motion-Sensor Light Switch in a Stairway, Step 7: Install the Cover Plate

    Once the wiring is complete and neatly tucked into the electrical box, mount the new motion sensor switch using the existing, longer screws that were previously removed. Point out the small tab on the side of the switch that is used for advanced programming. For this installation, the switch will be left in its default settings, and programming details will be covered in a separate video. Finally, install the cover plate, securing it with the appropriate screws.

  2. 5:30–5:53 Test Switch Operation From How to Install a Motion-Sensor Light Switch in a Stairway, Step 8: Restore Power and Test

    Return to the electrical panel and turn the circuit breaker back on to restore power to the circuit. Proceed to the room where the switch was installed. Enter the room to test the motion sensor. The light should automatically turn on upon detecting your presence. Then, leave the room and observe the light; it should automatically turn off after approximately 5 minutes, confirming the successful installation and operation of the switch in its default occupancy mode.

The guide that use this video

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

How to Install the Lutron Maestro Motion Sensor Light Switch — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.