powered by

Remove Existing Switch Plate and Switch

From How to Install a Motion-Sensor Light Switch in a Stairway · Step 2 of 8 · Video by Today's Homeowner with Danny Lipford

Showing 27:53–28:00 of the source video. Watch the full video with every moment.

What happens in this clip

Carefully use a screwdriver to remove the screws holding the cover plate of the existing light switch. Once the cover plate is off, unscrew the screws that secure the light switch to the electrical box. Gently pull the switch out from the wall, exposing the wiring connected to it.

Goal: Access the existing wiring

What's used

Tools

  • Cover Plate
  • Existing Light Switch
  • Screwdriver

About the full video

This project provides step-by-step instructions on how to replace a standard single-pole light switch with a dimmer switch. It covers essential safety precautions, wiring details, and tips for proper installation, allowing homeowners to easily upgrade their lighting control.

Step 2 of 8: Remove Existing Switch Plate and Switch

Unscrew and remove the cover plate of the existing light switch. Then, unscrew the old light switch from the electrical box. Carefully pull the switch out from the box to expose the wiring. Note or take a picture of how the wires are connected to the old switch.

Open this step in the guide

Every video in How to Install a Motion-Sensor Light Switch in a Stairway

  1. Step 1: Turn Off Power

  2. Step 2: Remove Existing Switch Plate and Switch

  3. Step 3: Identify and Disconnect Wires

  4. Step 4: Connect Motion Sensor Switch - Line and Load

  5. Step 5: Connect Ground Wire

  6. Step 6: Mount the Motion Sensor Switch

  7. Step 7: Install the Cover Plate

  8. Step 8: Restore Power and Test

How to Install a Motion-Sensor Light Switch in a Stairway

This project outlines the steps for installing a motion sensor light switch to automate lighting in a stairway. It covers preparation, wiring, mounting, and testing the new switch.

Read the full guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Remove Existing Switch Plate and Switch — How to Install a Motion-Sensor Light Switch in a Stairway | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.