Restore Power and Test Functionality
From How to Install a Motion-Sensor Light Switch in a Stairway · Step 8 of 8 · Video by Home & Garden for Mere Mortals

Showing 2:14–2:58 of the source video. Watch the full video with every moment.
What happens in this clip
Once all physical and electrical connections are made and adjustments are set, return to your main electrical panel. Flip the circuit breaker for the outdoor lights back to the 'ON' position to restore power. Test the motion-activated light by simulating motion in its detection zone. The video shows the light successfully activating in the dark, demonstrating proper installation and function.
Goal: Verify the correct operation of the motion-activated light and finalize settings.
What's used
Tools
- Circuit Breaker Panel
About the full video
This project provides a step-by-step guide on how to replace an existing outdoor light fixture with a new motion-activated security light. The process covers essential electrical safety, proper wiring techniques for hot, neutral, and ground wires, physical mounting of the fixture, and final adjustments for light positioning and motion sensor settings. The goal is to enhance home security, safety, and convenience.
Step 8 of 8: Restore Power and Test
Return to the circuit breaker panel and flip the breaker back to the 'ON' position. Wait a few moments for the motion sensor to calibrate if required by the manufacturer. Walk into the area covered by the sensor to test if the light turns on automatically. Verify that the light turns off after the set period of inactivity.
Every video in How to Install a Motion-Sensor Light Switch in a Stairway
Step 1: Turn Off Power
- 0:37–0:52 Cut Power at Circuit Breaker
- 0:51–0:57 Turn off Power at Breaker
- 0:49–0:55 Disconnect Power
Step 2: Remove Existing Switch Plate and Switch
- 27:53–28:00 Remove Existing Switch Plate and Switch
- 0:25–0:34 Remove Existing Light Switch
- 1:46–2:24 Remove Existing Switch and Cover
Step 3: Identify and Disconnect Wires
- 0:05–0:24 Identify and Disconnect Wires
- 2:44–4:10 Disconnect Old Switch & Identify Wires
- 0:47–1:01 Disconnect the Wires Connected to the Outlet Switch
Step 4: Connect Motion Sensor Switch - Line and Load
- 0:34–0:47 Wire the New Motion Sensor Switch
- 5:45–6:30 Wire the Motion Sensor Switch
- 0:05–0:11 Wire New Motion Sensor Switch
Step 5: Connect Ground Wire
- 3:28–3:58 Connect Ground Wires
- 0:52–0:58 Connect the Ground Wire
- 0:59–1:07 Connect Ground Wire to New Switch
Step 6: Mount the Motion Sensor Switch
- 0:11–0:12 Mount Motion Sensor Switch
- 0:47–0:55 Mount Switch and Attach Faceplate
- 2:41–3:07 Mount Switch and Adjust Settings
Step 7: Install the Cover Plate
- 7:43–7:51 Install Wall Plate
- 3:07–3:55 Install Cover Plate and Final Test
- 4:51–5:25 Mount Switch and Install Faceplate
Step 8: Restore Power and Test
- 2:14–2:58 Restore Power and Test Functionality (this video)
- 3:16–4:29 Restore Power and Test Functionality
- 5:30–5:53 Test Switch Operation
How to Install a Motion-Sensor Light Switch in a Stairway
This project outlines the steps for installing a motion sensor light switch to automate lighting in a stairway. It covers preparation, wiring, mounting, and testing the new switch.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

