Disconnect Power
From How to Install a Motion-Sensor Light Switch in a Stairway · Step 1 of 8 · Video by iScaper1

Showing 0:49–0:55 of the source video. Watch the full video with every moment.
What happens in this clip
To ensure safety before beginning electrical work, locate the circuit breaker panel for the house. Identify the breaker that controls the motion light fixture and switch it to the 'off' position. This will cut off power to the light.
Goal: Safely de-energize the light fixture.
What's used
Tools
- Breaker Panel
About the full video
This project guides you through replacing a faulty motion light sensor on an outdoor light fixture. The process involves safely disconnecting power, disassembling the old fixture, wiring the new sensor with the existing light arms, reassembling, and then adjusting the sensor's settings for optimal performance.
Step 1 of 8: Turn Off Power
Locate the circuit breaker that controls the stairway light. Flip the breaker to the 'OFF' position. It is crucial to verify that the power is off by attempting to operate the existing light switch. If the light does not turn on, the power is successfully cut.
Every video in How to Install a Motion-Sensor Light Switch in a Stairway
Step 1: Turn Off Power
- 0:37–0:52 Cut Power at Circuit Breaker
- 0:51–0:57 Turn off Power at Breaker
- 0:49–0:55 Disconnect Power (this video)
Step 2: Remove Existing Switch Plate and Switch
- 27:53–28:00 Remove Existing Switch Plate and Switch
- 0:25–0:34 Remove Existing Light Switch
- 1:46–2:24 Remove Existing Switch and Cover
Step 3: Identify and Disconnect Wires
- 0:05–0:24 Identify and Disconnect Wires
- 2:44–4:10 Disconnect Old Switch & Identify Wires
- 0:47–1:01 Disconnect the Wires Connected to the Outlet Switch
Step 4: Connect Motion Sensor Switch - Line and Load
- 0:34–0:47 Wire the New Motion Sensor Switch
- 5:45–6:30 Wire the Motion Sensor Switch
- 0:05–0:11 Wire New Motion Sensor Switch
Step 5: Connect Ground Wire
- 3:28–3:58 Connect Ground Wires
- 0:52–0:58 Connect the Ground Wire
- 0:59–1:07 Connect Ground Wire to New Switch
Step 6: Mount the Motion Sensor Switch
- 0:11–0:12 Mount Motion Sensor Switch
- 0:47–0:55 Mount Switch and Attach Faceplate
- 2:41–3:07 Mount Switch and Adjust Settings
Step 7: Install the Cover Plate
- 7:43–7:51 Install Wall Plate
- 3:07–3:55 Install Cover Plate and Final Test
- 4:51–5:25 Mount Switch and Install Faceplate
Step 8: Restore Power and Test
- 2:14–2:58 Restore Power and Test Functionality
- 3:16–4:29 Restore Power and Test Functionality
- 5:30–5:53 Test Switch Operation
How to Install a Motion-Sensor Light Switch in a Stairway
This project outlines the steps for installing a motion sensor light switch to automate lighting in a stairway. It covers preparation, wiring, mounting, and testing the new switch.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

