Cut Power at Circuit Breaker
From How to Install a Motion-Sensor Light Switch in a Stairway · Step 1 of 8 · Video by The DIY Guide

Showing 0:37–0:52 of the source video. Watch the full video with every moment.
What happens in this clip
Crucially, before touching any wiring, turn off the electricity to the light switch at the main electrical panel (breaker box). Locate the breaker that controls the specific light switch you are working on and switch it to the 'OFF' position. Always double-check to ensure power is off using a voltage tester (not shown but highly recommended for safety).
Goal: Safely de-energize the circuit connected to the light switch.
What's used
Tools
- Circuit Breaker Panel Leviton
About the full video
This DIY project provides step-by-step instructions on how to bypass a wall-mounted light switch to ensure that a connected appliance, such as a security camera, remains continuously powered. It involves safely disconnecting the switch from the circuit, directly connecting the load wires, and reinstalling the inactive switch for aesthetic purposes until a blank cover plate can be acquired. Crucially, the process emphasizes safety by requiring the power to be cut at the circuit breaker before any electrical work is performed.
Step 1 of 8: Turn Off Power
Locate the circuit breaker that controls the stairway light. Flip the breaker to the 'OFF' position. It is crucial to verify that the power is off by attempting to operate the existing light switch. If the light does not turn on, the power is successfully cut.
Every video in How to Install a Motion-Sensor Light Switch in a Stairway
Step 1: Turn Off Power
- 0:37–0:52 Cut Power at Circuit Breaker (this video)
- 0:51–0:57 Turn off Power at Breaker
- 0:49–0:55 Disconnect Power
Step 2: Remove Existing Switch Plate and Switch
- 27:53–28:00 Remove Existing Switch Plate and Switch
- 0:25–0:34 Remove Existing Light Switch
- 1:46–2:24 Remove Existing Switch and Cover
Step 3: Identify and Disconnect Wires
- 0:05–0:24 Identify and Disconnect Wires
- 2:44–4:10 Disconnect Old Switch & Identify Wires
- 0:47–1:01 Disconnect the Wires Connected to the Outlet Switch
Step 4: Connect Motion Sensor Switch - Line and Load
- 0:34–0:47 Wire the New Motion Sensor Switch
- 5:45–6:30 Wire the Motion Sensor Switch
- 0:05–0:11 Wire New Motion Sensor Switch
Step 5: Connect Ground Wire
- 3:28–3:58 Connect Ground Wires
- 0:52–0:58 Connect the Ground Wire
- 0:59–1:07 Connect Ground Wire to New Switch
Step 6: Mount the Motion Sensor Switch
- 0:11–0:12 Mount Motion Sensor Switch
- 0:47–0:55 Mount Switch and Attach Faceplate
- 2:41–3:07 Mount Switch and Adjust Settings
Step 7: Install the Cover Plate
- 7:43–7:51 Install Wall Plate
- 3:07–3:55 Install Cover Plate and Final Test
- 4:51–5:25 Mount Switch and Install Faceplate
Step 8: Restore Power and Test
- 2:14–2:58 Restore Power and Test Functionality
- 3:16–4:29 Restore Power and Test Functionality
- 5:30–5:53 Test Switch Operation
How to Install a Motion-Sensor Light Switch in a Stairway
This project outlines the steps for installing a motion sensor light switch to automate lighting in a stairway. It covers preparation, wiring, mounting, and testing the new switch.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

