Restore Power and Test Functionality
From How to Install a Motion-Sensor Light Switch in a Stairway · Step 8 of 8 · Video by Vibrant Deals

Showing 3:16–4:29 of the source video. Watch the full video with every moment.
What happens in this clip
Return to your main electrical panel and turn the circuit breaker back on to restore power. Test the new occupancy sensor switch by entering the room or hallway. The light should automatically turn on. Observe the automatic shut-off feature, which is typically adjustable (e.g., from 15 seconds to 30 minutes). The video demonstrates a 30-second setting and mentions a manual override feature on the sensor, allowing you to turn the light off or on regardless of motion detection.
Goal: Verify proper operation of the new occupancy sensor.
What's used
Tools
- Circuit Breaker Box
About the full video
This DIY project details the conversion of one switch in a three-way lighting circuit into a blank plate and the other into a single-pole occupancy sensor switch. This allows for an automated, motion-activated lighting solution in a hallway or room, while disabling the second control point.
Step 8 of 8: Restore Power and Test
Return to the circuit breaker panel and flip the breaker back to the 'ON' position. Wait a few moments for the motion sensor to calibrate if required by the manufacturer. Walk into the area covered by the sensor to test if the light turns on automatically. Verify that the light turns off after the set period of inactivity.
Every video in How to Install a Motion-Sensor Light Switch in a Stairway
Step 1: Turn Off Power
- 0:37–0:52 Cut Power at Circuit Breaker
- 0:51–0:57 Turn off Power at Breaker
- 0:49–0:55 Disconnect Power
Step 2: Remove Existing Switch Plate and Switch
- 27:53–28:00 Remove Existing Switch Plate and Switch
- 0:25–0:34 Remove Existing Light Switch
- 1:46–2:24 Remove Existing Switch and Cover
Step 3: Identify and Disconnect Wires
- 0:05–0:24 Identify and Disconnect Wires
- 2:44–4:10 Disconnect Old Switch & Identify Wires
- 0:47–1:01 Disconnect the Wires Connected to the Outlet Switch
Step 4: Connect Motion Sensor Switch - Line and Load
- 0:34–0:47 Wire the New Motion Sensor Switch
- 5:45–6:30 Wire the Motion Sensor Switch
- 0:05–0:11 Wire New Motion Sensor Switch
Step 5: Connect Ground Wire
- 3:28–3:58 Connect Ground Wires
- 0:52–0:58 Connect the Ground Wire
- 0:59–1:07 Connect Ground Wire to New Switch
Step 6: Mount the Motion Sensor Switch
- 0:11–0:12 Mount Motion Sensor Switch
- 0:47–0:55 Mount Switch and Attach Faceplate
- 2:41–3:07 Mount Switch and Adjust Settings
Step 7: Install the Cover Plate
- 7:43–7:51 Install Wall Plate
- 3:07–3:55 Install Cover Plate and Final Test
- 4:51–5:25 Mount Switch and Install Faceplate
Step 8: Restore Power and Test
- 2:14–2:58 Restore Power and Test Functionality
- 3:16–4:29 Restore Power and Test Functionality (this video)
- 5:30–5:53 Test Switch Operation
How to Install a Motion-Sensor Light Switch in a Stairway
This project outlines the steps for installing a motion sensor light switch to automate lighting in a stairway. It covers preparation, wiring, mounting, and testing the new switch.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

