Turn off Power at Breaker
From How to Install a Motion-Sensor Light Switch in a Stairway · Step 1 of 8 · Video by DIY Playbook

Showing 0:51–0:57 of the source video. Watch the full video with every moment.
What happens in this clip
Locate your home's electrical panel (breaker box) and switch off the circuit breaker that controls the power to the light switch you intend to replace. To ensure power is completely off, return to the light switch and flip it on and off a few times, verifying that the lights do not turn on.
Goal: Safely de-energize the circuit connected to the light switch
What's used
Tools
- Circuit Breaker Panel
About the full video
This project provides verbose step-by-step instructions on how to install a Legrand Radiant Smart Dimmer Switch, replacing an existing standard light switch. It covers disconnecting power, removing the old switch, preparing and wiring the new smart dimmer, securing it in place, and finally, setting up and configuring the smart features using the Legrand Smart Lights smartphone application.
Step 1 of 8: Turn Off Power
Locate the circuit breaker that controls the stairway light. Flip the breaker to the 'OFF' position. It is crucial to verify that the power is off by attempting to operate the existing light switch. If the light does not turn on, the power is successfully cut.
Every video in How to Install a Motion-Sensor Light Switch in a Stairway
Step 1: Turn Off Power
- 0:37–0:52 Cut Power at Circuit Breaker
- 0:51–0:57 Turn off Power at Breaker (this video)
- 0:49–0:55 Disconnect Power
Step 2: Remove Existing Switch Plate and Switch
- 27:53–28:00 Remove Existing Switch Plate and Switch
- 0:25–0:34 Remove Existing Light Switch
- 1:46–2:24 Remove Existing Switch and Cover
Step 3: Identify and Disconnect Wires
- 0:05–0:24 Identify and Disconnect Wires
- 2:44–4:10 Disconnect Old Switch & Identify Wires
- 0:47–1:01 Disconnect the Wires Connected to the Outlet Switch
Step 4: Connect Motion Sensor Switch - Line and Load
- 0:34–0:47 Wire the New Motion Sensor Switch
- 5:45–6:30 Wire the Motion Sensor Switch
- 0:05–0:11 Wire New Motion Sensor Switch
Step 5: Connect Ground Wire
- 3:28–3:58 Connect Ground Wires
- 0:52–0:58 Connect the Ground Wire
- 0:59–1:07 Connect Ground Wire to New Switch
Step 6: Mount the Motion Sensor Switch
- 0:11–0:12 Mount Motion Sensor Switch
- 0:47–0:55 Mount Switch and Attach Faceplate
- 2:41–3:07 Mount Switch and Adjust Settings
Step 7: Install the Cover Plate
- 7:43–7:51 Install Wall Plate
- 3:07–3:55 Install Cover Plate and Final Test
- 4:51–5:25 Mount Switch and Install Faceplate
Step 8: Restore Power and Test
- 2:14–2:58 Restore Power and Test Functionality
- 3:16–4:29 Restore Power and Test Functionality
- 5:30–5:53 Test Switch Operation
How to Install a Motion-Sensor Light Switch in a Stairway
This project outlines the steps for installing a motion sensor light switch to automate lighting in a stairway. It covers preparation, wiring, mounting, and testing the new switch.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

