Remove Existing Light Switch
From How to Install a Motion-Sensor Light Switch in a Stairway · Step 2 of 8 · Video by Below Average DIY

Showing 0:25–0:34 of the source video. Watch the full video with every moment.
What happens in this clip
Using a screwdriver, unscrew the two visible screws holding the light switch faceplate to the wall. Carefully remove the faceplate. Next, unscrew the two screws holding the light switch body to the electrical box. Gently pull the old switch out of the wall box, exposing the electrical wires connected to it. This allows access to remove the existing wiring.
Goal: Detach the old light switch from the wall box to access its wiring
What's used
Tools
- Screwdriver Klein Tools
- Flathead screwdriver
About the full video
This project guides you through replacing a standard light switch with a motion sensor light switch in a garage. It covers turning off power, removing the old switch, wiring the new motion sensor switch, and finally installing it, enhancing convenience and saving energy.
Step 2 of 8: Remove Existing Switch Plate and Switch
Unscrew and remove the cover plate of the existing light switch. Then, unscrew the old light switch from the electrical box. Carefully pull the switch out from the box to expose the wiring. Note or take a picture of how the wires are connected to the old switch.
Every video in How to Install a Motion-Sensor Light Switch in a Stairway
Step 1: Turn Off Power
- 0:37–0:52 Cut Power at Circuit Breaker
- 0:51–0:57 Turn off Power at Breaker
- 0:49–0:55 Disconnect Power
Step 2: Remove Existing Switch Plate and Switch
- 27:53–28:00 Remove Existing Switch Plate and Switch
- 0:25–0:34 Remove Existing Light Switch (this video)
- 1:46–2:24 Remove Existing Switch and Cover
Step 3: Identify and Disconnect Wires
- 0:05–0:24 Identify and Disconnect Wires
- 2:44–4:10 Disconnect Old Switch & Identify Wires
- 0:47–1:01 Disconnect the Wires Connected to the Outlet Switch
Step 4: Connect Motion Sensor Switch - Line and Load
- 0:34–0:47 Wire the New Motion Sensor Switch
- 5:45–6:30 Wire the Motion Sensor Switch
- 0:05–0:11 Wire New Motion Sensor Switch
Step 5: Connect Ground Wire
- 3:28–3:58 Connect Ground Wires
- 0:52–0:58 Connect the Ground Wire
- 0:59–1:07 Connect Ground Wire to New Switch
Step 6: Mount the Motion Sensor Switch
- 0:11–0:12 Mount Motion Sensor Switch
- 0:47–0:55 Mount Switch and Attach Faceplate
- 2:41–3:07 Mount Switch and Adjust Settings
Step 7: Install the Cover Plate
- 7:43–7:51 Install Wall Plate
- 3:07–3:55 Install Cover Plate and Final Test
- 4:51–5:25 Mount Switch and Install Faceplate
Step 8: Restore Power and Test
- 2:14–2:58 Restore Power and Test Functionality
- 3:16–4:29 Restore Power and Test Functionality
- 5:30–5:53 Test Switch Operation
How to Install a Motion-Sensor Light Switch in a Stairway
This project outlines the steps for installing a motion sensor light switch to automate lighting in a stairway. It covers preparation, wiring, mounting, and testing the new switch.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

