powered by

Secure Staircase Bottom

From How to Build Basement Stairs · Step 5 of 9 · Video by HouseImprovements

Showing 18:03–22:29 of the source video. Watch the full video with every moment.

What happens in this clip

To prevent the staircase from shifting, place wooden blocks between the stringers at the bottom. Use a hammer drill to create pilot holes in the concrete floor where the blocks will be placed. Secure the blocks to the concrete using concrete screws. It's crucial to know the location of any in-floor heating lines if applicable, to avoid damaging them. Alternatively, pressure-treated wood can be glued directly to the concrete. Once the blocks are secured, place the bottom riser against them and drive screws through the riser into these blocks, effectively locking the entire staircase in place. Before final tightening, check that the bottom riser is level from side to side; if not, use shims underneath the stringers to adjust. The video demonstrates using two screws per block.

Goal: Install wooden blocks between the stringers at the bottom, securing them to the concrete floor, and then attach the bottom riser to these blocks to prevent staircase movement.

What's used

Tools

  • Concrete drill bit
  • Concrete screws
  • Hammer drill
  • Level
  • Measuring tape
  • Shims
  • Wooden blocks

About the full video

This video provides a detailed guide on how to assemble and install a wooden staircase in a basement, focusing on securing stringers, attaching risers and treads, and waterproofing the stringer bases to prevent moisture damage. The process involves pre-cutting components, using construction adhesive and screws for strong bonds, and ensuring proper alignment and stability.

Step 5 of 9: Secure Bottom of Stringers

The bottom of the stringers must be firmly secured to prevent the stairs from shifting or tipping. If resting on a concrete slab, you can use concrete anchors (like Tapcons) to secure wooden blocks to the slab, and then screw the stringers to these blocks. If resting on a wooden subfloor or a framed landing, attach solid wood blocking or a sturdy footing to the subfloor, and then secure the stringers to this blocking using screws or hangers. Ensure the stringers are plumb and properly spaced before final fastening.

Open this step in the guide

Every video in How to Build Basement Stairs

  1. Step 1: Measure and Plan Stair Location

  2. Step 2: Cut Stair Stringers

  3. Step 3: Install Top Support for Stringers

  4. Step 4: Attach Stringers to Top Support

  5. Step 5: Secure Bottom of Stringers

  6. Step 6: Cut and Install Treads

  7. Step 7: Cut and Install Risers (Optional but Recommended)

  8. Step 8: Install Handrails and Balusters

  9. Step 9: Sand and Finish Treads and Risers

How to Build Basement Stairs

This project outlines the steps for building a safe and code-compliant set of stairs to a basement. It covers planning, material selection, cutting, assembly, and finishing, emphasizing structural integrity and safety features.

Read the full guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Secure Staircase Bottom — How to Build Basement Stairs | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.