powered by

Building Stairs - Assemble and install

Video by HouseImprovements · 2 moments used in Oak Valley Designs's DIY guides · 26:47 long

Moments in this video

  1. 10:15–17:22 Install Risers and Treads From How to Build Basement Stairs, Step 6: Cut and Install Treads

    Starting from the top, apply construction adhesive to the face of the stringers where the next riser will be placed. Position the riser and secure it to the stringers with screws. Then, apply adhesive to the top edge of the installed riser and the exposed edges of the stringers where the tread will sit. Place the pre-made OSB stair tread (1 inch thick with a bullnose edge) onto the stringers and secure it with screws. Continue this process for all remaining risers and treads, moving down the staircase. For added stability, drive screws from the back of each riser into the corresponding tread. Ensure the overhang of each tread is consistent. The video demonstrates using 3-inch screws for the treads.

  2. 18:03–22:29 Secure Staircase Bottom From How to Build Basement Stairs, Step 5: Secure Bottom of Stringers

    To prevent the staircase from shifting, place wooden blocks between the stringers at the bottom. Use a hammer drill to create pilot holes in the concrete floor where the blocks will be placed. Secure the blocks to the concrete using concrete screws. It's crucial to know the location of any in-floor heating lines if applicable, to avoid damaging them. Alternatively, pressure-treated wood can be glued directly to the concrete. Once the blocks are secured, place the bottom riser against them and drive screws through the riser into these blocks, effectively locking the entire staircase in place. Before final tightening, check that the bottom riser is level from side to side; if not, use shims underneath the stringers to adjust. The video demonstrates using two screws per block.

The guide that use this video

More from the Oak Valley Designs DIY Hub

Read the guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Building Stairs - Assemble and install — step-by-step moments | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.