powered by

Sand the Staircase

From How to Build Basement Stairs · Step 9 of 9 · Video by DIY RESCUE - Justin Bender Helps Teach remodeling

Showing 0:37–0:41 of the source video. Watch the full video with every moment.

What happens in this clip

Once all risers, treads, and landing flooring are installed, it's time to sand the entire staircase. Begin with 80-grit sandpaper on a random orbital sander to smooth out any imperfections, remove glue residue, and level minor height differences. Work your way through finer grits, typically 120-grit, then finish with 220-grit sandpaper for a smooth, ready-to-finish surface. Use a detail sander or sanding block for corners and tight spots that the orbital sander cannot reach. Connect your sander to a dust extractor or shop vac to minimize dust, and thoroughly clean all surfaces with a tack cloth or vacuum before moving to the next step.

Goal: Achieve a smooth, uniform surface for finishing

What's used

Tools

  • Detail Sander / Sanding Block
  • Hand sanding with sandpaper
  • edges
  • and tight spots.
  • Dust Extractor / Shop Vac
  • Dust Mask
  • Random Orbital Sander
  • more aggressive)
  • Vibrating sander
  • Safety Glasses
  • Tack Cloth

Materials

  • 120-grit Sandpaper
  • 220-grit Sandpaper
  • 80-grit Sandpaper

About the full video

This project details the transformation of an old, carpeted staircase into a beautiful hardwood staircase. It involves removing the existing carpet and treads, precisely measuring and installing new risers and treads, laying matching hardwood flooring on the landings, and finally sanding, staining, and applying a durable topcoat for a polished, long-lasting finish.

What's said in this clip

the Treads and install with the glue and 16 gauge nails use three quarter inch oak flooring for your Landings sand from 80 to 120 to 220 then take your stain and apply with a nice synthetic brush before you put on your top coat this is a floor finish Crystal Clear satin four coats and here is the

Automatically transcribed from the source video.

Step 9 of 9: Sand and Finish Treads and Risers

Once the stairs are fully assembled and all fasteners are countersunk or flush, begin the finishing process. Sand all surfaces of the treads and risers to remove any rough spots, splinters, or pencil marks. Start with a medium-grit sandpaper and finish with a fine-grit for a smooth feel. Clean off all dust thoroughly. Apply your chosen finish according to the manufacturer's instructions. This usually involves multiple coats with light sanding between coats for paint or stain. Sealant or polyurethane will protect the wood from wear and moisture.

Open this step in the guide

Every video in How to Build Basement Stairs

  1. Step 1: Measure and Plan Stair Location

  2. Step 2: Cut Stair Stringers

  3. Step 3: Install Top Support for Stringers

  4. Step 4: Attach Stringers to Top Support

  5. Step 5: Secure Bottom of Stringers

  6. Step 6: Cut and Install Treads

  7. Step 7: Cut and Install Risers (Optional but Recommended)

  8. Step 8: Install Handrails and Balusters

  9. Step 9: Sand and Finish Treads and Risers

How to Build Basement Stairs

This project outlines the steps for building a safe and code-compliant set of stairs to a basement. It covers planning, material selection, cutting, assembly, and finishing, emphasizing structural integrity and safety features.

Read the full guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Sand the Staircase — How to Build Basement Stairs | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.