powered by

Apply Adhesive and Install Treads

From How to Build Basement Stairs · Step 6 of 9 · Video by Essential Craftsman

Showing 10:10–11:50 of the source video. Watch the full video with every moment.

What happens in this clip

Cut OSB or plywood to the correct dimensions for the stair treads. Apply a generous bead of construction adhesive along the top edges of all stringers and intermediate support blocks for each step. Carefully place each tread board onto the adhesive-covered surfaces, ensuring it is flush with the risers and properly aligned. Use a nail gun to temporarily secure the treads in place with nails. The nails hold the treads until the adhesive cures, providing a strong, squeak-free connection. Ensure the treads are perfectly flat and level before the adhesive sets.

Goal: Apply construction adhesive to the top edges of the stringers and supports, then place and nail the OSB treads, ensuring they are flat and level.

What's used

Tools

  • Circular Saw
  • Construction Adhesive (Liquid Nails Heavy Duty)
  • Hammer
  • Level (Master Level)
  • Measuring Tape
  • Nail Gun (Hitachi)
  • OSB/Plywood (for treads)

About the full video

This video details the process of correcting a previously misbuilt staircase. It covers the removal of non-code-compliant stringers, adjustment of the header for an additional rise, precise calculation and marking of new stringer dimensions, cutting and installation of notched stringers, and final securing of risers and treads to create a safe, code-compliant, and comfortable staircase.

Step 6 of 9: Cut and Install Treads

Measure the depth of each step opening (the run) and the width of the stairs. Cut your tread material to these dimensions. The treads should typically overhang the riser by about 1 inch. Common tread materials include 2x lumber (like pine or oak), plywood, or specially made stair treads. Treads are usually attached by screwing through the stringer into the underside of the tread, or by using specialized tread brackets. For a cleaner look, you can notch the stringers to accept the treads, but ensure this does not compromise the stringer's strength. Ensure treads are level and securely fastened.

Open this step in the guide

Every video in How to Build Basement Stairs

  1. Step 1: Measure and Plan Stair Location

  2. Step 2: Cut Stair Stringers

  3. Step 3: Install Top Support for Stringers

  4. Step 4: Attach Stringers to Top Support

  5. Step 5: Secure Bottom of Stringers

  6. Step 6: Cut and Install Treads

  7. Step 7: Cut and Install Risers (Optional but Recommended)

  8. Step 8: Install Handrails and Balusters

  9. Step 9: Sand and Finish Treads and Risers

How to Build Basement Stairs

This project outlines the steps for building a safe and code-compliant set of stairs to a basement. It covers planning, material selection, cutting, assembly, and finishing, emphasizing structural integrity and safety features.

Read the full guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Apply Adhesive and Install Treads — How to Build Basement Stairs | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.