Screed the Concrete

What happens in this clip

After pouring the dry concrete mix, use a long, straight piece of lumber (often called a screed board) to level the surface. Place the screed board across the top edges of the wooden form and pull it in a back-and-forth sawing motion across the concrete. This process removes excess concrete and creates a relatively flat and even surface.

Goal: Level the concrete surface within the form

What's used

Tools

• Screed Board
• Straight edge

About the full video

This project outlines the process of creating a small, level concrete pad, likely for an outdoor unit or a small foundation. It involves preparing a wooden form, filling it with gravel and concrete mix, leveling the surface, and finishing the edges, followed by misting for proper curing.

Step 6 of 10: Screed the Concrete

Using a straight piece of lumber (such as a 2x4) as a screed board, rest it on top of the 2x6 formwork. Move the screed board back and forth in a sawing motion across the surface of the wet concrete, dragging excess concrete with it and filling low spots. This process levels the concrete to the height of the form.

Open this step in the guide

Every video in How to Pour a Concrete Landing Pad for Deck Stairs

1. Step 1: Excavate Area

   • 13:17–15:33 Prepare Stair Base and Pour Concrete Pad
   • 0:04–0:15 Site Preparation and Trench Digging
   • 4:20–8:36 Prepare & Pour Concrete Pad

2. Step 2: Install Formwork

   • 2:04–2:33 Build and Position Concrete Form
   • 0:33–0:47 Formwork Installation
   • 0:00–0:34 Lay Out and Assemble Initial Form Boards

3. Step 3: Add and Compact Gravel Base

   • 2:21–2:33 Add & Compact Basecourse
   • 3:15–4:05 Lay and Compact Gravel Base
   • 0:20–0:38 Prepare Gravel Base

4. Step 4: Place Rebar or Wire Mesh

   • 2:45–3:06 Add Steel Reinforcement (Rebar)
   • 1:30–1:40 Add Wire Mesh Reinforcement
   • 5:41–6:46 Rebar Placement for Reinforcement

5. Step 5: Mix and Pour Concrete

   • 0:30–0:42 Pour and Level Concrete
   • 3:10–3:41 Pour and Screed Concrete
   • 1:58–2:31 Mix and Pour Concrete

6. Step 6: Screed the Concrete

   • 0:04–0:13 Screed the Concrete (this video)
   • 0:24–1:01 Screed the Concrete Surface
   • 0:17–0:45 Screed the Concrete Surface

7. Step 7: Float the Concrete

   • 0:16–0:25 Float the Concrete Surface
   • 0:44–0:46 Hand Float Concrete Surface
   • 1:15–1:29 Float Concrete

8. Step 8: Finish the Concrete

   • 0:07–0:11 Trowel for Smooth Concrete Finish
   • 10:04–11:22 Final Troweling and Finishing
   • 3:30–4:49 Concrete Floating and Troweling

9. Step 9: Cure the Concrete

   • 2:08–2:39 Cure Concrete
   • 0:57–0:59 Cure Concrete and Remove Forms
   • 5:50–6:12 Cure the Concrete

10. Step 10: Remove Formwork

    • 8:43–10:04 Remove Form and Backfill
    • 4:03–4:08 Remove Formwork
    • 0:52–0:54 Remove Formwork