Fill Concrete Cracks
From How to Resurface Worn Concrete Steps · Step 2 of 6 · Video by Today's Homeowner with Danny Lipford

Showing 1:07–1:26 of the source video. Watch the full video with every moment.
What happens in this clip
Prepare the concrete crack filler by pouring the Quikrete patching material into a 5-gallon bucket. Gradually add water while mixing with a mixing paddle attached to a half-inch chuck drill. Continue mixing until a fairly thick, spreadable consistency is achieved, similar to cookie dough. This thick mixture is then carefully poured directly into the cleaned concrete cracks. Use a flat-edge trowel to force the material deep into the cracks, ensuring it fills all voids, and then smooth out the surface flush with the surrounding concrete. This prepares the cracks for a seamless resurfacing.
Goal: Repair the large cracks in the concrete slab.
What's used
Tools
- 5-gallon Bucket Home Depot (likely)
- Large mortar tub
- Flat-edge Trowel
- Concrete float
- Half-inch Chuck Drill
- Mixing Paddle
- Mortar mixer
Materials
- Quikrete Concrete Patching Material Quikrete
- Epoxy concrete crack filler
- Water
About the full video
This DIY project demonstrates how to repair large cracks in a concrete patio and then apply a concrete resurfacer to create a uniform, new surface. The process involves thorough cleaning, filling the cracks with a thick concrete patching mixture, allowing it to dry, and then applying a thinner resurfacing compound with a squeegee and broom finish to achieve a fresh, slip-resistant surface.
Step 2 of 6: Repair Cracks and Damage
For cracks less than 1/4 inch wide, use a flexible concrete crack filler. For wider cracks, holes, or spalled areas, use a concrete patching compound. Follow the manufacturer's instructions for mixing and application. For patching compounds, ensure you overfill slightly to allow for shrinkage. Smooth the patch flush with the surrounding concrete surface using a trowel.
Every video in How to Resurface Worn Concrete Steps
Step 1: Inspect and Clean Concrete Steps
- 0:35–0:58 Clean and Prepare Damaged Steps
- 0:13–0:35 Clean Concrete Stairs
- 1:19–2:05 Cleaning the Concrete Surface
Step 2: Repair Cracks and Damage
- 1:07–1:26 Fill Concrete Cracks (this video)
- 2:52–3:20 Apply and Level Patching Compound
- 0:00–0:10 Apply Crack Filler
Step 3: Prime the Surface
- 4:24–5:41 Prime the Concrete Surface
- 0:04–0:09 Prepare and Prime the Concrete Surface
- 4:17–5:40 Apply Concrete Bonding Adhesive
Step 4: Mix and Apply Concrete Resurfacer
- 0:13–0:21 Mix Concrete Resurfacing Product
- 2:22–3:19 Apply and Texture Concrete Resurfacer
- 0:21–0:39 Apply Thin Layer of Resurfacer
Step 5: Texture and Finish
- 16:32–16:40 Achieve Desired Finish
- 0:40–0:45 Apply Broom Finish (Optional)
- 1:16–1:25 Apply Textured Finish
Step 6: Cure the Resurfacer
- 0:33–0:40 Cure Resurfaced Concrete
- 0:12–0:15 Cure and Inspect
- 0:54–1:02 Cure Resurfaced Steps
How to Resurface Worn Concrete Steps
This project outlines the steps to resurface worn concrete steps, including cleaning, repairing cracks, applying a bonding agent, and finishing with a concrete resurfacer product.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

