Clean and Prepare Damaged Steps
From How to Resurface Worn Concrete Steps · Step 1 of 6 · Video by Mike Haduck Masonry

Showing 0:35–0:58 of the source video. Watch the full video with every moment.
What happens in this clip
Begin by inspecting the cement steps for damage, noting chipped edges, cracks, and holes. Use a wire brush to vigorously scrub and remove all loose concrete, dirt, and debris from the damaged areas. After brushing, rinse the entire work area with a garden hose to wash away residual loose material. Immediately use a sponge to remove any standing water, leaving the surface clean and damp, but not overtly wet, which is crucial for proper adhesion of the new cement.
Goal: Remove loose debris and moisten the steps for new cement application.
What's used
Tools
- Garden hose with nozzle
- Sponge
- Squeegee
- Wire brush
- Chisel and hammer for larger loose pieces
About the full video
This project guides you through repairing chipped, cracked, and holed cement steps using a rapid-set cement product. The process includes thoroughly cleaning the existing steps, mixing the cement, applying it to damaged areas, shaping and smoothing the patches, and finally, preparing the entire surface for a paint-ready finish, making the old steps look like new.
Step 1 of 6: Inspect and Clean Concrete Steps
Begin by sweeping away loose dirt and debris. For stubborn stains or grease, use a concrete degreaser and a stiff-bristled brush, followed by a thorough rinse with water. Ensure the concrete is completely dry before proceeding. Inspect the steps for any cracks, spalling, or crumbling areas that will need repair.
Every video in How to Resurface Worn Concrete Steps
Step 1: Inspect and Clean Concrete Steps
- 0:35–0:58 Clean and Prepare Damaged Steps (this video)
- 0:13–0:35 Clean Concrete Stairs
- 1:19–2:05 Cleaning the Concrete Surface
Step 2: Repair Cracks and Damage
- 1:07–1:26 Fill Concrete Cracks
- 2:52–3:20 Apply and Level Patching Compound
- 0:00–0:10 Apply Crack Filler
Step 3: Prime the Surface
- 4:24–5:41 Prime the Concrete Surface
- 0:04–0:09 Prepare and Prime the Concrete Surface
- 4:17–5:40 Apply Concrete Bonding Adhesive
Step 4: Mix and Apply Concrete Resurfacer
- 0:13–0:21 Mix Concrete Resurfacing Product
- 2:22–3:19 Apply and Texture Concrete Resurfacer
- 0:21–0:39 Apply Thin Layer of Resurfacer
Step 5: Texture and Finish
- 16:32–16:40 Achieve Desired Finish
- 0:40–0:45 Apply Broom Finish (Optional)
- 1:16–1:25 Apply Textured Finish
Step 6: Cure the Resurfacer
- 0:33–0:40 Cure Resurfaced Concrete
- 0:12–0:15 Cure and Inspect
- 0:54–1:02 Cure Resurfaced Steps
How to Resurface Worn Concrete Steps
This project outlines the steps to resurface worn concrete steps, including cleaning, repairing cracks, applying a bonding agent, and finishing with a concrete resurfacer product.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

