Apply Thin Layer of Resurfacer
From How to Resurface Worn Concrete Steps · Step 4 of 6 · Video by Andrew Thron Improvements

Showing 0:21–0:39 of the source video. Watch the full video with every moment.
What happens in this clip
Carefully pour the freshly mixed concrete resurfacing product directly onto the prepared concrete surface. Use a concrete hand trowel to spread the mixture evenly across the entire application area. Aim for a thin, consistent layer, approximately 1/16 of an inch (1.5 mm) thick. Repeat this process for all surfaces that need to be revitalized, including the flat top sections of the steps, horizontal treads, and vertical risers of the concrete porch or stairs.
Goal: Cover the old concrete with a new, smooth layer of resurfacing material
What's used
Tools
- Concrete Hand Trowel
- Margin trowel (for smaller areas)
- Large Mixing Bucket The Home Depot
- Work Gloves Firm Grip A1
Materials
- Mixed Concrete Resurfacing Product Rapid Set New-Crete
About the full video
This project guides you through revitalizing old, worn concrete surfaces, specifically porch steps, using a concrete resurfacing product. The process includes removing old fixtures, thorough cleaning, mixing and applying a thin layer of resurfacing material, and optionally adding a broom finish and concrete sealer for durability and aesthetics.
Step 4 of 6: Mix and Apply Concrete Resurfacer
In a clean mixing bucket, combine the concrete resurfacer powder with the recommended amount of clean water. Mix thoroughly with a drill equipped with a mixing paddle until a lump-free, workable consistency is achieved. The mixture should be like thick pancake batter. Immediately after mixing, pour the resurfacer onto the primed step and spread it evenly using a squeegee or trowel. Work from the top step downwards. Ensure consistent thickness across all surfaces.
Every video in How to Resurface Worn Concrete Steps
Step 1: Inspect and Clean Concrete Steps
- 0:35–0:58 Clean and Prepare Damaged Steps
- 0:13–0:35 Clean Concrete Stairs
- 1:19–2:05 Cleaning the Concrete Surface
Step 2: Repair Cracks and Damage
- 1:07–1:26 Fill Concrete Cracks
- 2:52–3:20 Apply and Level Patching Compound
- 0:00–0:10 Apply Crack Filler
Step 3: Prime the Surface
- 4:24–5:41 Prime the Concrete Surface
- 0:04–0:09 Prepare and Prime the Concrete Surface
- 4:17–5:40 Apply Concrete Bonding Adhesive
Step 4: Mix and Apply Concrete Resurfacer
- 0:13–0:21 Mix Concrete Resurfacing Product
- 2:22–3:19 Apply and Texture Concrete Resurfacer
- 0:21–0:39 Apply Thin Layer of Resurfacer (this video)
Step 5: Texture and Finish
- 16:32–16:40 Achieve Desired Finish
- 0:40–0:45 Apply Broom Finish (Optional)
- 1:16–1:25 Apply Textured Finish
Step 6: Cure the Resurfacer
- 0:33–0:40 Cure Resurfaced Concrete
- 0:12–0:15 Cure and Inspect
- 0:54–1:02 Cure Resurfaced Steps
How to Resurface Worn Concrete Steps
This project outlines the steps to resurface worn concrete steps, including cleaning, repairing cracks, applying a bonding agent, and finishing with a concrete resurfacer product.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

