Restore Power and Test Functionality
From Light Fixture Replacement · Step 12 of 13 · Video by Ask the Builder
Showing 1:36–1:44 of the source video.
What happens in this clip
After the fixture is fully installed, return to your circuit breaker panel and switch the power back on. Insert a working light bulb into the new fixture. Finally, flip the wall switch to test if your new light fixture is functioning correctly. If it doesn't work, retrace your steps to check connections and ensure the correct breaker was reset.
Goal: Verify the new light fixture is working properly
What's used
Tools
- Circuit Breaker Panel
- Light Bulb
- Light Switch
About the full video
This project provides step-by-step instructions on how to safely replace a temporary construction light fixture with a new, finished light fixture. It covers essential safety precautions, proper wire preparation, electrical connections, and final installation steps.
Step 12 of 13: Restore Power and Test
Return to the electrical panel and flip the circuit breaker back to the 'ON' position. Go to the light switch and turn on the new fixture to ensure it operates correctly. Check for any flickering or issues.
Other videos for this step
Light Fixture Replacement
This project involves safely removing an existing light fixture in a two-story stairwell and installing a new one. Due to the height and electrical work involved, safety precautions are paramount.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.