How to Install Carpet Treads on Stairs with an Open Side
About This Guide
A high-level outline for installing carpet treads on stairs with an open side. This involves preparing the stairs, cutting the carpet treads to size, and securely attaching them to the stairs, ensuring proper fit and adhesion, especially on the open side where additional care may be needed for a clean finish.
Tools & Materials
Karcher VCN 3 Bagless, Cordless Vacuum Cleaner - Lightweight Stick Vacuum + Handheld Vacuum, 3-Speed Power Control, HEPA Filter 1.012-910.0
Emsco 23 in. Plastic Handle and 6 in. Plastic Blade - Deluxe Snow Brush and Ice Scraper 1716-1
Karcher VCN 3 Bagless, Cordless Vacuum Cleaner - Lightweight Stick Vacuum + Handheld Vacuum, 3-Speed Power Control, HEPA Filter 1.012-910.0
Emsco 23 in. Plastic Handle and 6 in. Plastic Blade - Deluxe Snow Brush and Ice Scraper 1716-1
Steps
Clean Stair Treads
Vacuum each stair tread to remove loose dirt and dust. Then, use a stiff brush and a mild cleaning solution (like diluted dish soap) to scrub away any embedded dirt or grime. For stubborn adhesive residue, a plastic scraper or a solvent-specific adhesive remover may be necessary. Rinse the treads with a damp cloth and allow them to dry completely before proceeding.
Measure and Mark Carpet Treads
Using a tape measure, record the exact width and depth of each stair tread. For treads on the open side of the stairs, also measure the profile of the stair edge to ensure the carpet tread will wrap around cleanly. Transfer these measurements to the back of the carpet tread material, marking cut lines with a chalk line or a fabric marker.
Cut Carpet Treads
Using a sharp utility knife or heavy-duty scissors, carefully cut along the marked lines on the carpet tread material. For a clean cut, you may need to make multiple passes with the utility knife. Ensure that the cuts are straight and square, especially for the edges that will meet the riser or the open side of the stair.
Apply Adhesive
Depending on the type of carpet tread and adhesive used, apply a consistent layer of adhesive to either the back of the carpet tread, the stair tread surface, or both. Ensure even coverage, especially around the edges and corners, to promote full adhesion. For contact cement, apply to both surfaces and allow it to become tacky before joining.
Install Carpet Treads
Align the carpet tread with the stair tread, starting from the back and working forward. Press down firmly, using your hands or a small roller, to ensure good contact and adhesion. For the open side, carefully wrap the carpet around the edge and press it firmly into place, using a small piece of wood or a smooth tool to help conform the carpet to the stair profile.
Trim Excess Carpet
Once the adhesive has set, inspect the edges of the installed carpet treads. Carefully use a sharp utility knife to trim away any small pieces of excess carpet material that may have squeezed out or are protruding. Pay close attention to the open side to ensure a smooth, finished edge.
Questions about your project or which product fits? Oak Valley Designs's team is happy to help. Mon–Fri 9–5 ET





