Measure and Cut Carpet Tread
From How to Install Carpet Treads on Stairs with an Open Side · Step 2 of 6 · Video by Direct Carpet

Showing 0:12–0:57 of the source video. Watch the full video with every moment.
What happens in this clip
Using a tape measure, accurately measure the width of the stair tread where the carpet will sit. The installer measures 12.5 inches. He then decides to add a half-inch to the measurement, cutting the carpet to 13 inches, to ensure a very snug fit, noting that a previous piece was 'a little tight.' Unroll the carpet and use scissors to carefully cut a straight line across the carpet, following the measured width.
Goal: Prepare a carpet piece of appropriate size for the stair tread.
What's used
Tools
- Scissors
- Tape Measure
Materials
- Carpet Roll
About the full video
This DIY project details the step-by-step process of installing carpet treads on a wooden staircase, covering everything from securing padding and precise carpet cutting to stapling and finishing the edges for a clean, professional look.
Step 2 of 6: Measure and Mark Carpet Treads
Using a tape measure, record the exact width and depth of each stair tread. For treads on the open side of the stairs, also measure the profile of the stair edge to ensure the carpet tread will wrap around cleanly. Transfer these measurements to the back of the carpet tread material, marking cut lines with a chalk line or a fabric marker.
Every video in How to Install Carpet Treads on Stairs with an Open Side
Step 1: Clean Stair Treads
- 0:09–0:45 Prepare and Clean Stair Treads
- 0:34–0:40 Clean the Stairs
- 0:18–0:31 Clean the Stairs
Step 2: Measure and Mark Carpet Treads
- 0:12–0:57 Measure and Cut Carpet Tread (this video)
- 7:20–9:07 Measure and Cut Carpet
- 0:16–0:27 Measure and Cut Carpet Sections
Step 3: Cut Carpet Treads
- 8:08–9:23 Cut Carpet Pieces
- 0:12–0:57 Measure and Cut Carpet Tread
- 0:37–0:59 Measure and Cut Carpet
Step 4: Apply Adhesive
- 0:05–0:06 Apply Adhesive to Treads
- 0:34–0:46 Apply Carpet Adhesive to Stairs
- 0:33–0:39 Apply Adhesive and Lay First Pieces
Step 5: Install Carpet Treads
- 0:04–0:06 Install Carpet Treads
- 1:16–2:09 Install Carpet Treads with Adhesive
- 0:11–0:43 Install Remaining Carpet Stair Treads
Step 6: Trim Excess Carpet
- 1:28–2:59 Trim and Finish Edges
- 0:09–0:56 Trim Excess Carpet and Complete Installation
- 18:37–22:17 Trim and Tuck Side Edges
How to Install Carpet Treads on Stairs with an Open Side
A high-level outline for installing carpet treads on stairs with an open side. This involves preparing the stairs, cutting the carpet treads to size, and securely attaching them to the stairs, ensuring proper fit and adhesion, especially on the open side where additional care may be needed for a clean finish.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

