Apply Adhesive and Lay First Pieces
From How to Install Carpet Treads on Stairs with an Open Side · Step 4 of 6 · Video by Teirnan McCorkell

Showing 0:33–0:39 of the source video. Watch the full video with every moment.
What happens in this clip
With the first few carpet pieces cut, the installer takes them to the staircase. A moderate amount of spray adhesive is applied directly to the surface of the wooden stair treads and risers where the carpet will be placed. The pre-cut carpet piece is then carefully laid down onto the adhesive, ensuring it is correctly aligned.
Goal: Apply spray adhesive to the stair surfaces and carefully place the first pre-cut carpet pieces.
What's used
Tools
- Spray Adhesive
Materials
- Pre-cut Carpet Pieces
About the full video
This video demonstrates the full process of installing new carpet on a basement staircase using a direct glue-down method. It covers measuring individual stairs, precisely cutting carpet pieces, applying spray adhesive, and expertly fitting the carpet to each tread and riser for a clean, professional, and fully adhered finish.
Step 4 of 6: Apply Adhesive
Depending on the type of carpet tread and adhesive used, apply a consistent layer of adhesive to either the back of the carpet tread, the stair tread surface, or both. Ensure even coverage, especially around the edges and corners, to promote full adhesion. For contact cement, apply to both surfaces and allow it to become tacky before joining.
Every video in How to Install Carpet Treads on Stairs with an Open Side
Step 1: Clean Stair Treads
- 0:09–0:45 Prepare and Clean Stair Treads
- 0:34–0:40 Clean the Stairs
- 0:18–0:31 Clean the Stairs
Step 2: Measure and Mark Carpet Treads
- 0:12–0:57 Measure and Cut Carpet Tread
- 7:20–9:07 Measure and Cut Carpet
- 0:16–0:27 Measure and Cut Carpet Sections
Step 3: Cut Carpet Treads
- 8:08–9:23 Cut Carpet Pieces
- 0:12–0:57 Measure and Cut Carpet Tread
- 0:37–0:59 Measure and Cut Carpet
Step 4: Apply Adhesive
- 0:05–0:06 Apply Adhesive to Treads
- 0:34–0:46 Apply Carpet Adhesive to Stairs
- 0:33–0:39 Apply Adhesive and Lay First Pieces (this video)
Step 5: Install Carpet Treads
- 0:04–0:06 Install Carpet Treads
- 1:16–2:09 Install Carpet Treads with Adhesive
- 0:11–0:43 Install Remaining Carpet Stair Treads
Step 6: Trim Excess Carpet
- 1:28–2:59 Trim and Finish Edges
- 0:09–0:56 Trim Excess Carpet and Complete Installation
- 18:37–22:17 Trim and Tuck Side Edges
How to Install Carpet Treads on Stairs with an Open Side
A high-level outline for installing carpet treads on stairs with an open side. This involves preparing the stairs, cutting the carpet treads to size, and securely attaching them to the stairs, ensuring proper fit and adhesion, especially on the open side where additional care may be needed for a clean finish.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

