Measure and Cut Carpet
From How to Install Carpet Treads on Stairs with an Open Side · Step 2 of 6 · Video by Direct Carpet

Showing 7:20–9:07 of the source video. Watch the full video with every moment.
What happens in this clip
Measure the width of the stair tread from stringer to stringer (e.g., 36 1/8 inches) and the depth from the nose to the back riser (e.g., 13 inches). To allow for trimming and a snug fit, cut the carpet pieces slightly larger than these measurements (e.g., 37 inches wide by 14 inches deep). Use a utility knife and a straight edge to ensure clean, straight cuts. You will need one carpet piece per tread.
What's used
Tools
- Straight Edge
- Tape Measure
- Utility Knife
About the full video
This video provides detailed, step-by-step instructions on how to install carpet on stair treads using various trim tools to achieve a clean, professional finish. It covers preparing the stairs with tack strip and underpad, precise carpet cutting, and techniques for stretching, stapling, and tucking the carpet for a polished look.
Step 2 of 6: Measure and Mark Carpet Treads
Using a tape measure, record the exact width and depth of each stair tread. For treads on the open side of the stairs, also measure the profile of the stair edge to ensure the carpet tread will wrap around cleanly. Transfer these measurements to the back of the carpet tread material, marking cut lines with a chalk line or a fabric marker.
Every video in How to Install Carpet Treads on Stairs with an Open Side
Step 1: Clean Stair Treads
- 0:09–0:45 Prepare and Clean Stair Treads
- 0:34–0:40 Clean the Stairs
- 0:18–0:31 Clean the Stairs
Step 2: Measure and Mark Carpet Treads
- 0:12–0:57 Measure and Cut Carpet Tread
- 7:20–9:07 Measure and Cut Carpet (this video)
- 0:16–0:27 Measure and Cut Carpet Sections
Step 3: Cut Carpet Treads
- 8:08–9:23 Cut Carpet Pieces
- 0:12–0:57 Measure and Cut Carpet Tread
- 0:37–0:59 Measure and Cut Carpet
Step 4: Apply Adhesive
- 0:05–0:06 Apply Adhesive to Treads
- 0:34–0:46 Apply Carpet Adhesive to Stairs
- 0:33–0:39 Apply Adhesive and Lay First Pieces
Step 5: Install Carpet Treads
- 0:04–0:06 Install Carpet Treads
- 1:16–2:09 Install Carpet Treads with Adhesive
- 0:11–0:43 Install Remaining Carpet Stair Treads
Step 6: Trim Excess Carpet
- 1:28–2:59 Trim and Finish Edges
- 0:09–0:56 Trim Excess Carpet and Complete Installation
- 18:37–22:17 Trim and Tuck Side Edges
How to Install Carpet Treads on Stairs with an Open Side
A high-level outline for installing carpet treads on stairs with an open side. This involves preparing the stairs, cutting the carpet treads to size, and securely attaching them to the stairs, ensuring proper fit and adhesion, especially on the open side where additional care may be needed for a clean finish.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

