Clean the Stairs
From How to Install Carpet Treads on Stairs with an Open Side · Step 1 of 6 · Video by Slips Away UK

Showing 0:18–0:31 of the source video. Watch the full video with every moment.
What happens in this clip
Begin by ensuring your stairs are thoroughly clean. Use a dust pan and brush to sweep away all dirt, dust, and debris from top to bottom. Follow up by wiping down the surface of each stair with a damp rag to remove any lingering unwanted stains or marks. This critical step ensures optimal adhesion for the anti-slip treads.
Goal: Ensure stairs are clean and free of dirt, debris, stains, and marks.
What's used
Tools
- Damp rag
- Sponge
- Dust pan and brush
- Broom
About the full video
This video provides step-by-step instructions on how to easily install anti-slip stair treads on hardwood stairs, covering essential preparation, precise measurement for alignment, and proper application techniques to ensure a secure and bubble-free finish.
Step 1 of 6: Clean Stair Treads
Vacuum each stair tread to remove loose dirt and dust. Then, use a stiff brush and a mild cleaning solution (like diluted dish soap) to scrub away any embedded dirt or grime. For stubborn adhesive residue, a plastic scraper or a solvent-specific adhesive remover may be necessary. Rinse the treads with a damp cloth and allow them to dry completely before proceeding.
Every video in How to Install Carpet Treads on Stairs with an Open Side
Step 1: Clean Stair Treads
- 0:09–0:45 Prepare and Clean Stair Treads
- 0:34–0:40 Clean the Stairs
- 0:18–0:31 Clean the Stairs (this video)
Step 2: Measure and Mark Carpet Treads
- 0:12–0:57 Measure and Cut Carpet Tread
- 7:20–9:07 Measure and Cut Carpet
- 0:16–0:27 Measure and Cut Carpet Sections
Step 3: Cut Carpet Treads
- 8:08–9:23 Cut Carpet Pieces
- 0:12–0:57 Measure and Cut Carpet Tread
- 0:37–0:59 Measure and Cut Carpet
Step 4: Apply Adhesive
- 0:05–0:06 Apply Adhesive to Treads
- 0:34–0:46 Apply Carpet Adhesive to Stairs
- 0:33–0:39 Apply Adhesive and Lay First Pieces
Step 5: Install Carpet Treads
- 0:04–0:06 Install Carpet Treads
- 1:16–2:09 Install Carpet Treads with Adhesive
- 0:11–0:43 Install Remaining Carpet Stair Treads
Step 6: Trim Excess Carpet
- 1:28–2:59 Trim and Finish Edges
- 0:09–0:56 Trim Excess Carpet and Complete Installation
- 18:37–22:17 Trim and Tuck Side Edges
How to Install Carpet Treads on Stairs with an Open Side
A high-level outline for installing carpet treads on stairs with an open side. This involves preparing the stairs, cutting the carpet treads to size, and securely attaching them to the stairs, ensuring proper fit and adhesion, especially on the open side where additional care may be needed for a clean finish.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

