Trim and Tuck Side Edges
From How to Install Carpet Treads on Stairs with an Open Side · Step 6 of 6 · Video by Direct Carpet

Showing 18:37–22:17 of the source video. Watch the full video with every moment.
What happens in this clip
To achieve a perfectly clean edge against the side stringers, carefully lift the side carpet edge and use a sharp utility knife to trim away any excess carpet backing. Position the knife blade at a 45-degree angle and follow the line where the carpet meets the stringer. It's often best to remove one strip of backing at a time to avoid cutting too much. Once trimmed, use the carpet tucker to firmly push the newly cut edge into the gap between the tack strip and the stringer, ensuring a tight, clean line. If the carpet still bulges, trim slightly more backing. For Berber or loop pile carpets, you can also use scissors to trim fraying fibers along the edges. Repeat for both sides of the tread.
What's used
Tools
- Carpet Tucker
- Scissors
- Utility Knife
About the full video
This video provides detailed, step-by-step instructions on how to install carpet on stair treads using various trim tools to achieve a clean, professional finish. It covers preparing the stairs with tack strip and underpad, precise carpet cutting, and techniques for stretching, stapling, and tucking the carpet for a polished look.
Step 6 of 6: Trim Excess Carpet
Once the adhesive has set, inspect the edges of the installed carpet treads. Carefully use a sharp utility knife to trim away any small pieces of excess carpet material that may have squeezed out or are protruding. Pay close attention to the open side to ensure a smooth, finished edge.
Every video in How to Install Carpet Treads on Stairs with an Open Side
Step 1: Clean Stair Treads
- 0:09–0:45 Prepare and Clean Stair Treads
- 0:34–0:40 Clean the Stairs
- 0:18–0:31 Clean the Stairs
Step 2: Measure and Mark Carpet Treads
- 0:12–0:57 Measure and Cut Carpet Tread
- 7:20–9:07 Measure and Cut Carpet
- 0:16–0:27 Measure and Cut Carpet Sections
Step 3: Cut Carpet Treads
- 8:08–9:23 Cut Carpet Pieces
- 0:12–0:57 Measure and Cut Carpet Tread
- 0:37–0:59 Measure and Cut Carpet
Step 4: Apply Adhesive
- 0:05–0:06 Apply Adhesive to Treads
- 0:34–0:46 Apply Carpet Adhesive to Stairs
- 0:33–0:39 Apply Adhesive and Lay First Pieces
Step 5: Install Carpet Treads
- 0:04–0:06 Install Carpet Treads
- 1:16–2:09 Install Carpet Treads with Adhesive
- 0:11–0:43 Install Remaining Carpet Stair Treads
Step 6: Trim Excess Carpet
- 1:28–2:59 Trim and Finish Edges
- 0:09–0:56 Trim Excess Carpet and Complete Installation
- 18:37–22:17 Trim and Tuck Side Edges (this video)
How to Install Carpet Treads on Stairs with an Open Side
A high-level outline for installing carpet treads on stairs with an open side. This involves preparing the stairs, cutting the carpet treads to size, and securely attaching them to the stairs, ensuring proper fit and adhesion, especially on the open side where additional care may be needed for a clean finish.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

