Snap Off Screw Heads
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors · Step 5 of 6 · Video by LRN2DIY

Showing 4:49–5:22 of the source video. Watch the full video with every moment.
What happens in this clip
With the squeaks addressed, use the kit's screw-head snapping tool to remove the visible screw heads. Place the tool over the screw head, aligning the slot with the screw, and knock it to one side. The screw head will cleanly snap off at its weak point, leaving the remaining threaded portion securely holding the subfloor and joist together. The snapped-off portion can be discarded, and the carpet will cover the flush break point, making it unnoticeable.
Goal: Remove screw heads for a flush, invisible finish on carpeted floors.
What's used
Tools
- Screw-Head Snapping Tool Squeeeek No More
About the full video
This project provides a step-by-step guide on how to fix squeaky floors from above, using a specialized kit. The process involves identifying the direction of floor joists, locating the exact joist position, driving special screws to secure the subfloor to the joists, and then snapping off the screw heads for a flush finish. The video also briefly covers how to adapt the method for non-carpeted floors.
Step 5 of 6: Break Off Screw Heads (if applicable)
Many squeak repair kits include screws with heads designed to break off at a specific point. This leaves a clean finish and prevents the screw head from being a tripping hazard or visible. Once the screw is driven in, use needle-nose pliers or the tool provided in the kit to grip the screw head and snap it off. The aim is for the remaining shaft to be flush with or slightly below the carpet surface.
Every video in How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Step 1: Identify Squeak Location
- 0:00–0:17 Identify Squeak Location
- 0:00–0:09 Locate the Squeak
- 0:00–0:30 Locate Squeak and Assess Access
Step 2: Prepare the Squeak Repair Kit
Step 3: Drill Pilot Holes
- 0:15–0:24 Drill a Pilot Hole
- 4:17–5:45 Fix from Above: Use Trim Head Screws
- 4:08–4:43 Pre-Drill Pilot Holes
Step 4: Install Repair Screws
- 1:25–3:50 Install Specialized Repair Screws
- 2:56–3:28 Install Breakaway Repair Screws
- 2:48–3:49 Drive and Snap Off the Screw
Step 5: Break Off Screw Heads (if applicable)
- 3:48–4:38 Break Off the Screw Head
- 4:49–5:22 Snap Off Screw Heads (this video)
- 3:50–4:00 Break Off Screw Heads
Step 6: Test the Repaired Area
- 8:01–8:29 Test Repaired Floor
- 3:57–4:25 Repeat for All Squeaky Areas
- 0:38–0:48 Confirm Repair and Concealment
How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Outline for using a squeak-repair kit on carpeted stairs and floors to eliminate annoying squeaking sounds.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

