Pre-Drill Pilot Holes
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors · Step 3 of 6 · Video by The Home Improvements Channel UK

Showing 4:08–4:43 of the source video. Watch the full video with every moment.
What happens in this clip
Before driving any screws, it is essential to pre-drill pilot holes through the floorboard. This prevents the wood from splitting, especially in older or dry timber, and ensures the screw maintains its full clamping force. Drill a pilot hole slightly smaller than the screw's shank at each marked fixing point. The video demonstrates this process, illustrating where the pilot holes should be placed (e.g., in the center of the joist) and then later explicitly explains how pilot holes prevent splitting and maintain effective clamping force. The video also briefly shows a demonstration of what happens when a long screw is driven without prior inspection, serving as a visual warning against improper technique.
Goal: Prevent wood splitting and ensure secure screw fastening.
What's used
Tools
- Drill DeWalt
- Drill bit
About the full video
This project provides detailed instructions on how to properly and safely fix squeaky or loose floorboards. It emphasizes the crucial step of inspecting underneath the floor for pipes and cables to avoid costly damage, explains how to provide support for unstable boards, details the selection of appropriate screws and fixing patterns, and highlights the importance of pre-drilling pilot holes to ensure a secure and long-lasting repair.
Step 3 of 6: Drill Pilot Holes
The pilot hole guides the repair screw and helps prevent the carpet backing from tearing excessively. Use the specified drill bit from the kit. For optimal effectiveness, especially on floors, aim the drill at a slight angle towards the nearest floor joist. This helps the screw secure into the joist, providing better support. Be careful not to drill too deep, only penetrating the subfloor sufficiently to anchor the screw.
Every video in How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Step 1: Identify Squeak Location
- 0:00–0:17 Identify Squeak Location
- 0:00–0:09 Locate the Squeak
- 0:00–0:30 Locate Squeak and Assess Access
Step 2: Prepare the Squeak Repair Kit
Step 3: Drill Pilot Holes
- 0:15–0:24 Drill a Pilot Hole
- 4:17–5:45 Fix from Above: Use Trim Head Screws
- 4:08–4:43 Pre-Drill Pilot Holes (this video)
Step 4: Install Repair Screws
- 1:25–3:50 Install Specialized Repair Screws
- 2:56–3:28 Install Breakaway Repair Screws
- 2:48–3:49 Drive and Snap Off the Screw
Step 5: Break Off Screw Heads (if applicable)
- 3:48–4:38 Break Off the Screw Head
- 4:49–5:22 Snap Off Screw Heads
- 3:50–4:00 Break Off Screw Heads
Step 6: Test the Repaired Area
- 8:01–8:29 Test Repaired Floor
- 3:57–4:25 Repeat for All Squeaky Areas
- 0:38–0:48 Confirm Repair and Concealment
How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Outline for using a squeak-repair kit on carpeted stairs and floors to eliminate annoying squeaking sounds.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

