Install Specialized Repair Screws
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors · Step 4 of 6 · Video by This Old House

Showing 1:25–3:50 of the source video. Watch the full video with every moment.
What happens in this clip
Place the Squeak-Ender tripod tool over a marked joist line. Insert a specialized repair screw (which has a break-off head) into the driver bit, and then into the tripod tool. Apply downward pressure on the tripod with your feet to compress the carpet and subfloor tightly against the joist. Drive the screw through the carpet and subfloor into the joist until the tripod's stop mechanism prevents further driving. The screw is designed to stop at a specific height, just above the subfloor. Repeat this process, placing screws approximately every 8 inches along each marked joist line.
Goal: Using a drill and a specialized Squeak-Ender tripod tool with screws designed to break below the carpet, install screws along the marked joist lines every 8 inches to secure the subfloor.
What's used
Tools
- Cordless Drill
- Driver Bit Squeak-Ender
- Special Floor Repair Screws Squeak-Ender
- Squeak-Ender Tripod Tool Squeak-Ender
About the full video
This video demonstrates a method for silencing squeaky floors in carpeted rooms without removing the carpet. It involves locating floor joists, installing specialized screws through the carpet and subfloor into the joists, and then cleanly breaking off the screw heads below the carpet surface using a specialized tool, effectively securing the subfloor and eliminating squeaks.
Step 4 of 6: Install Repair Screws
With the pilot holes drilled, insert the repair screws. These screws are typically designed with a break-off head or a mechanism to allow the visible portion to be removed or countersunk. Attach the appropriate screw-driving bit to your drill and carefully drive the screw. Stop when the screw is snug and has effectively pulled the carpet and subfloor tightly together, eliminating the gap causing the squeak. The goal is to create a tight bond that stops movement.
Every video in How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Step 1: Identify Squeak Location
- 0:00–0:17 Identify Squeak Location
- 0:00–0:09 Locate the Squeak
- 0:00–0:30 Locate Squeak and Assess Access
Step 2: Prepare the Squeak Repair Kit
Step 3: Drill Pilot Holes
- 0:15–0:24 Drill a Pilot Hole
- 4:17–5:45 Fix from Above: Use Trim Head Screws
- 4:08–4:43 Pre-Drill Pilot Holes
Step 4: Install Repair Screws
- 1:25–3:50 Install Specialized Repair Screws (this video)
- 2:56–3:28 Install Breakaway Repair Screws
- 2:48–3:49 Drive and Snap Off the Screw
Step 5: Break Off Screw Heads (if applicable)
- 3:48–4:38 Break Off the Screw Head
- 4:49–5:22 Snap Off Screw Heads
- 3:50–4:00 Break Off Screw Heads
Step 6: Test the Repaired Area
- 8:01–8:29 Test Repaired Floor
- 3:57–4:25 Repeat for All Squeaky Areas
- 0:38–0:48 Confirm Repair and Concealment
How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Outline for using a squeak-repair kit on carpeted stairs and floors to eliminate annoying squeaking sounds.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

