Test Repaired Floor
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors · Step 6 of 6 · Video by The Fixer

Showing 8:01–8:29 of the source video. Watch the full video with every moment.
What happens in this clip
Walk firmly over the areas that previously squeaked. Listen carefully to confirm that the floor is now solid and quiet. If any minor squeaks persist, repeat the process of locating and securing those specific spots with additional screws.
Goal: Perform a final test by walking across the repaired area to confirm that all squeaks have been successfully eliminated.
About the full video
This video provides a DIY guide on how to eliminate annoying floorboard squeaks using wood screws. The primary method involves accessing the subfloor from above by temporarily removing a vinyl floor tile, then securing the subfloor to the joists with wood screws. An alternative method, applicable if access from below is possible and there's a gap between the subfloor and joist, involves installing a 'sleeper' piece of wood.
What's said in this clip
squeak. And I felt that definitely went into the floor joist. Let's see. Hey look at that. I got a little squeak but that's back further this way. Do you remember what it was like before? There's no squeak there so that is awesome. So it took a
Automatically transcribed from the source video.
Step 6 of 6: Test the Repaired Area
After installing the screw and breaking off the head, put weight back on the repaired spot. Walk on it firmly to see if the squeak is gone. If you still hear a squeak, it's possible the screw didn't fully engage the joist, or there might be multiple points of friction. You can try inserting another screw adjacent to the first, or slightly repositioning the original screw in its pilot hole if it allows. Repeat the process if necessary until the squeak is resolved.
Every video in How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Step 1: Identify Squeak Location
- 0:00–0:17 Identify Squeak Location
- 0:00–0:09 Locate the Squeak
- 0:00–0:30 Locate Squeak and Assess Access
Step 2: Prepare the Squeak Repair Kit
Step 3: Drill Pilot Holes
- 0:15–0:24 Drill a Pilot Hole
- 4:17–5:45 Fix from Above: Use Trim Head Screws
- 4:08–4:43 Pre-Drill Pilot Holes
Step 4: Install Repair Screws
- 1:25–3:50 Install Specialized Repair Screws
- 2:56–3:28 Install Breakaway Repair Screws
- 2:48–3:49 Drive and Snap Off the Screw
Step 5: Break Off Screw Heads (if applicable)
- 3:48–4:38 Break Off the Screw Head
- 4:49–5:22 Snap Off Screw Heads
- 3:50–4:00 Break Off Screw Heads
Step 6: Test the Repaired Area
- 8:01–8:29 Test Repaired Floor (this video)
- 3:57–4:25 Repeat for All Squeaky Areas
- 0:38–0:48 Confirm Repair and Concealment
How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Outline for using a squeak-repair kit on carpeted stairs and floors to eliminate annoying squeaking sounds.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

