Locate Squeak and Assess Access
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors · Step 1 of 6 · Video by Soundproof Guide

Showing 0:00–0:30 of the source video. Watch the full video with every moment.
What happens in this clip
Begin by actively listening to your staircase to pinpoint the exact location of the creak or squeak. The most common source is where the vertical risers meet the horizontal treads. Carefully inspect these joints for any visible cracks or gaps. If a crack is present, this indicates movement between the wood components, which causes the squeaking. If you cannot access the underside of the staircase, a temporary solution involves applying dried graphite into these cracks to reduce friction.
Goal: Pinpoint the source of the squeak and determine accessibility
What's used
Materials
- Dried Graphite
- Wood lubricant
About the full video
This project provides step-by-step instructions on how to fix squeaky stairs by identifying the source of the squeak, which is typically due to movement between the stair risers and treads. The solution involves applying construction adhesive and then securing these components with drywall screws from underneath the staircase, ultimately eliminating the unwanted noise.
Step 1 of 6: Identify Squeak Location
The first crucial step is to accurately locate the source of the squeak. This often involves a process of elimination by systematically walking over the affected areas. Pay close attention to where the sound originates. Once identified, mark the spot. For stairs, this might be on the tread or riser. For floors, it could be near a seam or in the middle of a wider expanse.
Every video in How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Step 1: Identify Squeak Location
- 0:00–0:17 Identify Squeak Location
- 0:00–0:09 Locate the Squeak
- 0:00–0:30 Locate Squeak and Assess Access (this video)
Step 2: Prepare the Squeak Repair Kit
Step 3: Drill Pilot Holes
- 0:15–0:24 Drill a Pilot Hole
- 4:17–5:45 Fix from Above: Use Trim Head Screws
- 4:08–4:43 Pre-Drill Pilot Holes
Step 4: Install Repair Screws
- 1:25–3:50 Install Specialized Repair Screws
- 2:56–3:28 Install Breakaway Repair Screws
- 2:48–3:49 Drive and Snap Off the Screw
Step 5: Break Off Screw Heads (if applicable)
- 3:48–4:38 Break Off the Screw Head
- 4:49–5:22 Snap Off Screw Heads
- 3:50–4:00 Break Off Screw Heads
Step 6: Test the Repaired Area
- 8:01–8:29 Test Repaired Floor
- 3:57–4:25 Repeat for All Squeaky Areas
- 0:38–0:48 Confirm Repair and Concealment
How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Outline for using a squeak-repair kit on carpeted stairs and floors to eliminate annoying squeaking sounds.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

