Repeat for All Squeaky Areas
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors · Step 6 of 6 · Video by Mad Buildz

Showing 3:57–4:25 of the source video. Watch the full video with every moment.
What happens in this clip
Continue the process of locating joists, drilling pilot holes, testing with the joist finder screw, and then driving scored screws in all areas where you hear squeaks. After driving each screw, test the floor by walking over it to check if the squeak has been eliminated or significantly reduced. Repeat until you are satisfied with the results.
Goal: Eliminate all noticeable squeaks across the floor.
What's used
Tools
- Cordless Drill Makita
- Drill Bit (1/8 inch)
- Drive Bit Squeak No More
- Hardwood Floor Adapter Squeak No More
- Impact Driver Makita
- Joist Finder Screw Squeak No More
- Specialty Scored Screws Squeak No More
About the full video
This project provides detailed instructions on how to fix squeaky hardwood floors using a specialized kit called 'Squeak No More'. The process involves identifying the loudest squeak, locating floor joists, drilling pilot holes, driving scored screws to secure the subfloor to the joists, and then filling the resulting holes with wood putty for a finished look.
Step 6 of 6: Test the Repaired Area
After installing the screw and breaking off the head, put weight back on the repaired spot. Walk on it firmly to see if the squeak is gone. If you still hear a squeak, it's possible the screw didn't fully engage the joist, or there might be multiple points of friction. You can try inserting another screw adjacent to the first, or slightly repositioning the original screw in its pilot hole if it allows. Repeat the process if necessary until the squeak is resolved.
Every video in How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Step 1: Identify Squeak Location
- 0:00–0:17 Identify Squeak Location
- 0:00–0:09 Locate the Squeak
- 0:00–0:30 Locate Squeak and Assess Access
Step 2: Prepare the Squeak Repair Kit
Step 3: Drill Pilot Holes
- 0:15–0:24 Drill a Pilot Hole
- 4:17–5:45 Fix from Above: Use Trim Head Screws
- 4:08–4:43 Pre-Drill Pilot Holes
Step 4: Install Repair Screws
- 1:25–3:50 Install Specialized Repair Screws
- 2:56–3:28 Install Breakaway Repair Screws
- 2:48–3:49 Drive and Snap Off the Screw
Step 5: Break Off Screw Heads (if applicable)
- 3:48–4:38 Break Off the Screw Head
- 4:49–5:22 Snap Off Screw Heads
- 3:50–4:00 Break Off Screw Heads
Step 6: Test the Repaired Area
- 8:01–8:29 Test Repaired Floor
- 3:57–4:25 Repeat for All Squeaky Areas (this video)
- 0:38–0:48 Confirm Repair and Concealment
How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Outline for using a squeak-repair kit on carpeted stairs and floors to eliminate annoying squeaking sounds.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

