Break Off Screw Heads
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors · Step 5 of 6 · Video by This Old House

Showing 3:50–4:00 of the source video. Watch the full video with every moment.
What happens in this clip
Once all repair screws are installed, retrieve the Squeak-Ender tripod tool. Position the tool over each screw head, ensuring the attachment aligns with the screw head. With a firm push and a slight twist or downward motion (as designed by the tool), snap off the exposed screw head. The design of the screw and tool ensures the break occurs cleanly below the carpet surface, making the screw virtually invisible and unnoticeable.
Goal: Use the Squeak-Ender tripod tool to cleanly snap off the heads of all installed repair screws, leaving them invisible beneath the carpet.
What's used
Tools
- Squeak-Ender Tripod Tool Squeak-Ender
About the full video
This video demonstrates a method for silencing squeaky floors in carpeted rooms without removing the carpet. It involves locating floor joists, installing specialized screws through the carpet and subfloor into the joists, and then cleanly breaking off the screw heads below the carpet surface using a specialized tool, effectively securing the subfloor and eliminating squeaks.
Step 5 of 6: Break Off Screw Heads (if applicable)
Many squeak repair kits include screws with heads designed to break off at a specific point. This leaves a clean finish and prevents the screw head from being a tripping hazard or visible. Once the screw is driven in, use needle-nose pliers or the tool provided in the kit to grip the screw head and snap it off. The aim is for the remaining shaft to be flush with or slightly below the carpet surface.
Every video in How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Step 1: Identify Squeak Location
- 0:00–0:17 Identify Squeak Location
- 0:00–0:09 Locate the Squeak
- 0:00–0:30 Locate Squeak and Assess Access
Step 2: Prepare the Squeak Repair Kit
Step 3: Drill Pilot Holes
- 0:15–0:24 Drill a Pilot Hole
- 4:17–5:45 Fix from Above: Use Trim Head Screws
- 4:08–4:43 Pre-Drill Pilot Holes
Step 4: Install Repair Screws
- 1:25–3:50 Install Specialized Repair Screws
- 2:56–3:28 Install Breakaway Repair Screws
- 2:48–3:49 Drive and Snap Off the Screw
Step 5: Break Off Screw Heads (if applicable)
- 3:48–4:38 Break Off the Screw Head
- 4:49–5:22 Snap Off Screw Heads
- 3:50–4:00 Break Off Screw Heads (this video)
Step 6: Test the Repaired Area
- 8:01–8:29 Test Repaired Floor
- 3:57–4:25 Repeat for All Squeaky Areas
- 0:38–0:48 Confirm Repair and Concealment
How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Outline for using a squeak-repair kit on carpeted stairs and floors to eliminate annoying squeaking sounds.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

