Drill a Pilot Hole
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors · Step 3 of 6 · Video by Cody Steck

Showing 0:15–0:24 of the source video. Watch the full video with every moment.
What happens in this clip
With the joist located, select a drill bit that is slightly smaller in diameter than the core of the specialized repair screw you will be using. Attach the drill bit to a cordless power drill. Carefully drill a pilot hole through the floorboard and into the center of the identified subfloor joist. The purpose of this pilot hole is to guide the screw accurately and prevent any splitting or damage to the flooring material as the screw is driven in.
Goal: Create a pilot hole for the specialized repair screw.
What's used
Tools
- Drill Bit
- Power Drill DeWalt
- Impact driver
About the full video
This DIY project provides a simple and effective method to eliminate squeaks in wooden flooring. It involves identifying the problematic areas, locating the underlying subfloor joists, drilling pilot holes, and then using specialized screws that snap off below the surface to secure the floorboards to the joists, effectively stopping the squeaking.
Step 3 of 6: Drill Pilot Holes
The pilot hole guides the repair screw and helps prevent the carpet backing from tearing excessively. Use the specified drill bit from the kit. For optimal effectiveness, especially on floors, aim the drill at a slight angle towards the nearest floor joist. This helps the screw secure into the joist, providing better support. Be careful not to drill too deep, only penetrating the subfloor sufficiently to anchor the screw.
Every video in How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Step 1: Identify Squeak Location
- 0:00–0:17 Identify Squeak Location
- 0:00–0:09 Locate the Squeak
- 0:00–0:30 Locate Squeak and Assess Access
Step 2: Prepare the Squeak Repair Kit
Step 3: Drill Pilot Holes
- 0:15–0:24 Drill a Pilot Hole (this video)
- 4:17–5:45 Fix from Above: Use Trim Head Screws
- 4:08–4:43 Pre-Drill Pilot Holes
Step 4: Install Repair Screws
- 1:25–3:50 Install Specialized Repair Screws
- 2:56–3:28 Install Breakaway Repair Screws
- 2:48–3:49 Drive and Snap Off the Screw
Step 5: Break Off Screw Heads (if applicable)
- 3:48–4:38 Break Off the Screw Head
- 4:49–5:22 Snap Off Screw Heads
- 3:50–4:00 Break Off Screw Heads
Step 6: Test the Repaired Area
- 8:01–8:29 Test Repaired Floor
- 3:57–4:25 Repeat for All Squeaky Areas
- 0:38–0:48 Confirm Repair and Concealment
How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Outline for using a squeak-repair kit on carpeted stairs and floors to eliminate annoying squeaking sounds.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

