Confirm Repair and Concealment
From How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors · Step 6 of 6 · Video by Chris Garage78

Showing 0:38–0:48 of the source video. Watch the full video with every moment.
What happens in this clip
After snapping off the screw head, gently run your fingers or hand over the carpet in the repaired area. The broken-off portion of the screw should be completely concealed beneath the carpet fibers, leaving no visible or palpable trace. If you can feel any part of the screw, you might need to try driving another screw nearby or ensuring the snap-off was complete. Finally, walk across the previously squeaky section of the floor. The floorboard should now be securely fastened, and the annoying squeak should be gone, resulting in a solid, noise-free floor.
Goal: Gently rub the carpet over the repaired area to ensure the screw head is completely hidden and cannot be felt. Then, walk across the treated area to verify that the squeak has been eliminated.
About the full video
This video demonstrates a method for fixing squeaky floorboards in carpeted areas using a specialized break-away screw and a guiding jig. The process involves driving a screw through the carpet and into the subfloor to secure loose floorboards, then snapping off the screw head just below the carpet surface for an invisible repair.
Step 6 of 6: Test the Repaired Area
After installing the screw and breaking off the head, put weight back on the repaired spot. Walk on it firmly to see if the squeak is gone. If you still hear a squeak, it's possible the screw didn't fully engage the joist, or there might be multiple points of friction. You can try inserting another screw adjacent to the first, or slightly repositioning the original screw in its pilot hole if it allows. Repeat the process if necessary until the squeak is resolved.
Every video in How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Step 1: Identify Squeak Location
- 0:00–0:17 Identify Squeak Location
- 0:00–0:09 Locate the Squeak
- 0:00–0:30 Locate Squeak and Assess Access
Step 2: Prepare the Squeak Repair Kit
Step 3: Drill Pilot Holes
- 0:15–0:24 Drill a Pilot Hole
- 4:17–5:45 Fix from Above: Use Trim Head Screws
- 4:08–4:43 Pre-Drill Pilot Holes
Step 4: Install Repair Screws
- 1:25–3:50 Install Specialized Repair Screws
- 2:56–3:28 Install Breakaway Repair Screws
- 2:48–3:49 Drive and Snap Off the Screw
Step 5: Break Off Screw Heads (if applicable)
- 3:48–4:38 Break Off the Screw Head
- 4:49–5:22 Snap Off Screw Heads
- 3:50–4:00 Break Off Screw Heads
Step 6: Test the Repaired Area
- 8:01–8:29 Test Repaired Floor
- 3:57–4:25 Repeat for All Squeaky Areas
- 0:38–0:48 Confirm Repair and Concealment (this video)
How to Use a Squeak-Repair Kit on Carpeted Stairs and Floors
Outline for using a squeak-repair kit on carpeted stairs and floors to eliminate annoying squeaking sounds.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

