Repeat for All Risers and Measure Variation
From How to Measure Basement Stairs with Uneven Steps · Step 2 of 6 · Video by stairbuilding

Showing 1:24–1:56 of the source video. Watch the full video with every moment.
What happens in this clip
Proceed step by step, moving the block to each subsequent riser. For each riser, place the block on the tread and against the riser. If the current tread height doesn't align with any previous mark on the block, make a new mark. You should now have multiple marks on your block, representing all the different riser heights encountered. Once you have checked all risers (down to the very bottom step), use a measuring tape or ruler to find the maximum difference between any two marks on your block. This measurement represents the overall riser height variation across your staircase.
Goal: Continue this process for every riser down the staircase, marking the block each time a new height is observed. Once all risers are checked, measure the total difference between the highest and lowest marks on the block.
What's used
Tools
- Measuring Tape or Ruler
- Scrap Lumber Block (with all marks)
About the full video
This video provides a simple, visual method to check the height variation of stair risers, ensuring compliance with common building codes that typically allow for a maximum of 3/8 inch variation between any two risers on a staircase. It demonstrates using a scrap block of wood to mark and compare riser heights from the top to the bottom of the staircase.
Step 2 of 6: Measure the Rise of Each Step
Using a tape measure and a level, accurately measure the vertical distance between the top surface of one tread and the top surface of the tread directly above it. Start at the bottom of the stairs and work your way up, measuring the rise at both the left and right sides of each step, as well as in the center. Record these measurements for each step. Consistent rise is crucial for comfortable and safe stair use. Note any significant variations.
Every video in How to Measure Basement Stairs with Uneven Steps
Step 1: Inspect the Stairs for Visible Unevenness
Step 2: Measure the Rise of Each Step
- 0:24–0:39 Measure Inconsistent Step Rise Heights
- 1:24–1:56 Repeat for All Risers and Measure Variation (this video)
- 0:31–1:01 Measure Riser Height and Tread Depth Consistency
Step 3: Measure the Run of Each Step
- 0:00–0:03 Measure Individual Stair Components
- 2:54–4:47 Measure Straight Stairs
- 0:52–2:34 Measuring Rise and Run
Step 4: Check for Plumb and Level of Treads and Risers
- 0:19–0:51 Level and Align Installed Riser
- 2:22–2:42 Diagnose Stair Fit Problems and Causes
- 12:00–14:21 Check Tread Level and Stringer Fit
Step 5: Measure Overall Staircase Dimensions
- 0:04–0:28 Measure Total Rise
- 1:05–3:09 Determine Staircase Dimensions
- 0:04–0:30 Measure Total Rise
Step 6: Document All Measurements
- 0:01–0:28 Measure Total Vertical Rise
- 0:54–1:25 Calculate Final Total Rise
- 0:43–1:29 Measure Total Staircase Height (Method 1)
How to Measure Basement Stairs with Uneven Steps
Outline for measuring uneven basement stairs to prepare for leveling or repair. This involves identifying the extent of the unevenness and taking precise measurements of each step's rise and run to plan corrective actions.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

