Diagnose Stair Fit Problems and Causes
From How to Measure Basement Stairs with Uneven Steps · Step 4 of 6 · Video by stairbuilding

Showing 2:22–2:42 of the source video. Watch the full video with every moment.
What happens in this clip
The video provides a comprehensive checklist for diagnosing stair fit problems. It clarifies that a 'Gap at the Top Back' indicates individual riser heights are likely too long, while a 'Gap at the Bottom Front' suggests they are too short. If risers are 'Out of Plumb,' the tread run will never be level. Beyond mathematical errors, external factors like structural settling and shifting (foundation sinking, joist shrinkage), improper stringer installation/mounting (not securely fastened), material warping (moisture content, low-quality lumber), and subfloor or landing irregularities (debris, unlevel subfloor) can all contribute to misaligned stairs. A 'Stair Calculator Checklist' advises measuring 'Total Rise' from finished lower to upper floor, calculating 'Individual Riser' (Total Rise / Number of Risers), and applying the 'Drop Rule' (subtracting tread material thickness from the bottom of the stringer).
Goal: This step outlines specific symptoms (gaps, out of plumb/level) and their likely causes related to stair stringer fit, including calculation errors and external structural/material factors.
What's used
Tools
- Framing Square
- Level
- Measuring Tape
About the full video
This video details the importance of accurate stair stringer layout marking for precise rise and run for each step. It visually demonstrates the consequences of incorrect riser height calculations, leading to gaps at the top or bottom of the stairs and out-of-plumb risers. The video emphasizes a 'test before you trash' approach by cutting and verifying a single pattern stringer before committing to all cuts, and provides a checklist for proper stair calculation and external factors to consider for optimal stair construction.
Step 4 of 6: Check for Plumb and Level of Treads and Risers
Place a long level across the width of each tread to check if it is level from side to side and front to back. Then, use a level or a plumb bob to check if the vertical face of each riser is plumb (perfectly vertical). Any significant deviations from level or plumb indicate that the stairs may have settled unevenly or were not constructed correctly.
Every video in How to Measure Basement Stairs with Uneven Steps
Step 1: Inspect the Stairs for Visible Unevenness
Step 2: Measure the Rise of Each Step
Step 3: Measure the Run of Each Step
- 0:00–0:03 Measure Individual Stair Components
- 2:54–4:47 Measure Straight Stairs
- 0:52–2:34 Measuring Rise and Run
Step 4: Check for Plumb and Level of Treads and Risers
- 0:19–0:51 Level and Align Installed Riser
- 2:22–2:42 Diagnose Stair Fit Problems and Causes (this video)
- 12:00–14:21 Check Tread Level and Stringer Fit
Step 5: Measure Overall Staircase Dimensions
- 0:04–0:28 Measure Total Rise
- 1:05–3:09 Determine Staircase Dimensions
- 0:04–0:30 Measure Total Rise
Step 6: Document All Measurements
- 0:01–0:28 Measure Total Vertical Rise
- 0:54–1:25 Calculate Final Total Rise
- 0:43–1:29 Measure Total Staircase Height (Method 1)
How to Measure Basement Stairs with Uneven Steps
Outline for measuring uneven basement stairs to prepare for leveling or repair. This involves identifying the extent of the unevenness and taking precise measurements of each step's rise and run to plan corrective actions.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

