Test Gate Functionality and Latch
From How to Install a Retractable Baby Gate on Stairs · Step 6 of 6 · Video by Handyman Hints

Showing 17:06–18:29 of the source video. Watch the full video with every moment.
What happens in this clip
Once the gate is securely installed, test its functionality. The gate latch typically requires a two-step action (e.g., pushing a button and lifting) to open, ensuring child safety. Let the gate swing open and then release it to confirm it automatically closes and latches properly. Adjust the tension bolts further if any looseness is detected or if the latch is not operating smoothly.
What's used
Tools
- Installed Child Safety Gate Babelio
About the full video
This video provides instructions for installing a Babelio child safety gate, focusing on achieving a secure installation. While primarily demonstrating pressure mounting, the guide also outlines the steps for wall mounting using included hardware such as wall cups, screws, and Molly bolts for a more reliable, permanent fixture in doorways or stairways.
Step 6 of 6: Test Gate Operation and Lock
Operate the gate through its full range of motion. Extend it fully to ensure it spans the opening adequately and that the locking mechanism engages securely. Retract the gate to ensure it does so smoothly without binding. Test the latching mechanism multiple times to verify it is easy to operate for adults but secure enough to prevent a child from opening it. Check that there are no gaps where a small child could slip through.
Every video in How to Install a Retractable Baby Gate on Stairs
Step 1: Determine Gate Placement
- 2:14–3:30 Mount Gate Assembly Brackets
- 0:39–0:47 Position Gate and Mark Wall Cups
- 0:24–0:31 Install Lower Wall Mounts (First Side)
Step 2: Mark Bracket Positions
- 3:17–4:33 Mark Latching Side Bracket Locations
- 0:30–0:47 Mark Gate Mount Positions
- 3:44–4:19 Secure Mounting Brackets (Side 2)
Step 3: Drill Pilot Holes
- 1:14–1:24 Drill Pilot Holes
- 1:58–2:05 Drill Pilot Holes
- 0:00–0:19 Drill Pilot Holes
Step 4: Mount the Brackets
- 1:56–2:34 Install Mounting Brackets
- 0:19–0:22 Mount Wall Brackets
- 8:16–10:38 Mount the Brackets
Step 5: Attach the Gate Mechanism
- 2:22–2:34 Install Retractable Gate
- 5:13–5:39 Install Gate onto Wall Fittings
- 7:06–8:41 Test Gate Operation and Tighten Adjustments
Step 6: Test Gate Operation and Lock
- 1:51–1:59 Test Gate Operation
- 3:05–3:19 Test Gate Operation and SecurTech Lock
- 17:06–18:29 Test Gate Functionality and Latch (this video)
How to Install a Retractable Baby Gate on Stairs
Install a retractable baby gate at the top or bottom of a staircase to ensure child safety. This typically involves mounting brackets to the wall or banister posts and then attaching the gate mechanism.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

