Mount the Brackets
From How to Install a Retractable Baby Gate on Stairs · Step 4 of 6 · Video by Danny Johnson’s Garage

Showing 8:16–10:38 of the source video. Watch the full video with every moment.
What happens in this clip
Align the first mounting bracket with the pencil line you previously drew. Use the pencil to mark the locations of the four screw holes inside the bracket. To ease installation, take one of the screws and tap it lightly with a hammer into each marked spot, just enough to break through the drywall and create small pilot holes. Then, use a cordless drill equipped with the appropriate bit (hex or Phillips, depending on your screw heads) to screw the bracket into place. Partially drive in all screws before fully tightening them, ensuring the bracket remains aligned with your marks. Repeat this process for the remaining mounting brackets on both sides and any center support brackets, ensuring they are also aligned with the marks or positioned appropriately if not directly against a marked line.
Goal: Securely install all mounting brackets into the window frame/wall
What's used
Tools
- Cordless Drill Craftsman
- Screwdriver
- Drill Bit
- Hammer Stanley
- Mounting Brackets
- Pencil Bic
- Screws
About the full video
This project provides a step-by-step guide on how to install window blinds, focusing on the crucial step of assembling and positioning the decorative valence first to ensure correct placement of the mounting brackets. It covers attaching clips and corner pieces to the valence, accurately marking screw holes, installing the brackets, and finally mounting the blinds and reattaching the valence for a seamless finish.
Step 4 of 6: Mount the Brackets
Align each bracket with its corresponding pilot hole(s). Insert the provided screws through the bracket holes and into the pilot holes. If using drywall anchors, install them first according to their specific instructions, then drive the screws through the bracket and into the anchors. Use a screwdriver or drill with a driver bit to tighten the screws until the bracket is firmly secured to the mounting surface. Ensure there is no wobble or looseness in the mounted brackets. Repeat for all bracket locations.
Every video in How to Install a Retractable Baby Gate on Stairs
Step 1: Determine Gate Placement
- 2:14–3:30 Mount Gate Assembly Brackets
- 0:39–0:47 Position Gate and Mark Wall Cups
- 0:24–0:31 Install Lower Wall Mounts (First Side)
Step 2: Mark Bracket Positions
- 3:17–4:33 Mark Latching Side Bracket Locations
- 0:30–0:47 Mark Gate Mount Positions
- 3:44–4:19 Secure Mounting Brackets (Side 2)
Step 3: Drill Pilot Holes
- 1:14–1:24 Drill Pilot Holes
- 1:58–2:05 Drill Pilot Holes
- 0:00–0:19 Drill Pilot Holes
Step 4: Mount the Brackets
- 1:56–2:34 Install Mounting Brackets
- 0:19–0:22 Mount Wall Brackets
- 8:16–10:38 Mount the Brackets (this video)
Step 5: Attach the Gate Mechanism
- 2:22–2:34 Install Retractable Gate
- 5:13–5:39 Install Gate onto Wall Fittings
- 7:06–8:41 Test Gate Operation and Tighten Adjustments
Step 6: Test Gate Operation and Lock
- 1:51–1:59 Test Gate Operation
- 3:05–3:19 Test Gate Operation and SecurTech Lock
- 17:06–18:29 Test Gate Functionality and Latch
How to Install a Retractable Baby Gate on Stairs
Install a retractable baby gate at the top or bottom of a staircase to ensure child safety. This typically involves mounting brackets to the wall or banister posts and then attaching the gate mechanism.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

