Mount Gate Assembly Brackets
From How to Install a Retractable Baby Gate on Stairs · Step 1 of 6 · Video by Bog Life

Showing 2:14–3:30 of the source video. Watch the full video with every moment.
What happens in this clip
Measure the exact distance from the edge of the wall to where the lower gate mount will start. Repeat this measurement for the top. Attach the lower gate mount directly into the baseboard using a drill to drive the screws. To find the exact placement for the upper gate mount, install the gate assembly into the lower mount, attach the upper gate mount to the upper portion of the gate assembly, level it against the wall, and mark its position with a pencil. Then, pre-drill holes and install wall anchors (plugs). Finally, secure the upper mount, using a wall spacer to ensure it is level with the lower mount.
Goal: Securely attach the upper and lower gate mounts on the left side of the opening, ensuring they are level.
What's used
Tools
- Cordless Drill RYOBI
- Drill Bit
- Gate Assembly EasyBaby
- Level
- Lower Gate Mount
- Pencil
- Marker
- Screws
- Tape Measure
- Yardstick
- Upper Gate Mount
- Wall Anchors (Plugs)
- Wall Spacer
About the full video
This video provides step-by-step instructions for installing an EasyBaby retractable safety gate at the edge of a staircase, addressing considerations for installation distance, and demonstrating how to customize the installation for unique banister configurations using wooden spacers.
Step 1 of 6: Determine Gate Placement
Assess the intended location for the baby gate. For top-of-stair installation, identify two vertical mounting surfaces (wall studs or banister posts) that are plumb and provide sufficient width for the gate. For bottom-of-stair installation, the same applies. Ensure that the chosen location allows the gate to swing open fully without obstruction and that the retraction mechanism will have a clear path. Consider the height of the mounting points to align with the gate's operational range. Use a level to mark potential bracket positions to ensure they are aligned horizontally.
Every video in How to Install a Retractable Baby Gate on Stairs
Step 1: Determine Gate Placement
- 2:14–3:30 Mount Gate Assembly Brackets (this video)
- 0:39–0:47 Position Gate and Mark Wall Cups
- 0:24–0:31 Install Lower Wall Mounts (First Side)
Step 2: Mark Bracket Positions
- 3:17–4:33 Mark Latching Side Bracket Locations
- 0:30–0:47 Mark Gate Mount Positions
- 3:44–4:19 Secure Mounting Brackets (Side 2)
Step 3: Drill Pilot Holes
- 1:14–1:24 Drill Pilot Holes
- 1:58–2:05 Drill Pilot Holes
- 0:00–0:19 Drill Pilot Holes
Step 4: Mount the Brackets
- 1:56–2:34 Install Mounting Brackets
- 0:19–0:22 Mount Wall Brackets
- 8:16–10:38 Mount the Brackets
Step 5: Attach the Gate Mechanism
- 2:22–2:34 Install Retractable Gate
- 5:13–5:39 Install Gate onto Wall Fittings
- 7:06–8:41 Test Gate Operation and Tighten Adjustments
Step 6: Test Gate Operation and Lock
- 1:51–1:59 Test Gate Operation
- 3:05–3:19 Test Gate Operation and SecurTech Lock
- 17:06–18:29 Test Gate Functionality and Latch
How to Install a Retractable Baby Gate on Stairs
Install a retractable baby gate at the top or bottom of a staircase to ensure child safety. This typically involves mounting brackets to the wall or banister posts and then attaching the gate mechanism.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

