powered by

Tension Cable Lines

From How to Tension and Adjust Stair Cable Railing · Step 7 of 8 · Video by Premier Outdoor Living

Showing 12:30–13:00 of the source video. Watch the full video with every moment.

What happens in this clip

Once all cable lines are threaded and fixed at one end, begin the tensioning process. Using a ratcheting wrench and an Allen key (Cobalt brand shown) on the tensioning hardware located on the exterior of the posts, tighten each cable. Work incrementally, tightening all cables evenly to avoid over-stressing any single line or distorting the posts. Continuously check the tension and ensure that the cables are taut and straight. The goal is to achieve a tight, secure railing system that has minimal deflection and meets local building codes for safety (typically less than 4-inch spacing between cables).

Goal: This final step involves tightening the cable lines to the correct tension using a specialized wrench, ensuring the railing is taut, secure, and meets safety standards.

What's used

Tools

  • Allen Key (Cobalt brand shown) Cobalt
  • Cable Railing System (Installed)
  • Ratcheting Wrench

About the full video

This video details the process of installing a modern cable railing system on a deck, specifically focusing on the preparation and installation of posts, the insertion and tensioning of the cable lines, and ensuring the system adheres to safety codes for both horizontal and angled stair sections. The project highlights the importance of proper blocking and the use of specialized tools for a sleek, contemporary aesthetic.

Step 7 of 8: Secure Tensioning Device

Once the desired tension is achieved for each cable, secure the tensioning device to prevent it from backing off due to vibrations or environmental changes. If using a turnbuckle, some models come with locking nuts or mechanisms. For threaded rods, ensure the nuts are tightened firmly against the post or any locking washer. Consider using thread-locking compound for added security, especially in outdoor or high-vibration environments.

Open this step in the guide

Every video in How to Tension and Adjust Stair Cable Railing

  1. Step 1: Initial Cable Engagement

  2. Step 2: Attach Tensioning Fitting to First Cable End

  3. Step 3: Install Tensioning Device at Opposite End

  4. Step 4: Initial Cable Tensioning

  5. Step 5: Check for Sag and Vibration

  6. Step 6: Fine-Tuning Tension

  7. Step 7: Secure Tensioning Device

  8. Step 8: Final Inspection and Trim Excess Cable

How to Tension and Adjust Stair Cable Railing

This project outlines the steps to properly tension and adjust a cable railing system on a staircase, ensuring safety and a clean aesthetic.

Read the full guide Browse all guides

Planning this project? Shop Oak Valley Designs.

Tension Cable Lines — How to Tension and Adjust Stair Cable Railing | Oak Valley Designs

Subscribe for exclusive updates

Be the first to know about promotions, new products, and sales.