Final Cable Tensioning
From How to Tension and Adjust Stair Cable Railing · Step 6 of 8 · Video by Fine Homebuilding

Showing 1:09–1:18 of the source video. Watch the full video with every moment.
What happens in this clip
With all cables installed and hand-tightened, proceed to the final tensioning. Work from the center cables outwards to ensure even tension across the entire railing. Use a wrench or the manufacturer's specialized tensioning tool to tighten the adjustable hardware. Apply sufficient tension to make the cables taut, but be careful not to overtighten, which could damage the posts or hardware. Periodically check the tension and adjust as needed until all cables are uniformly tight and meet safety standards.
Goal: Achieve proper tension across all cables for safety and aesthetics.
What's used
Tools
- Manufacturer's Tensioning Tool
- Wrench
- Socket wrench
About the full video
This project provides a concise overview of installing cable railing on stairs. It covers essential layout considerations, including code-compliant spacing, proper hardware installation techniques, cable cutting and seating, and the final tensioning process to achieve a secure and aesthetically pleasing railing system.
Step 6 of 8: Fine-Tuning Tension
Based on the sag and vibration checks, make small, incremental adjustments to the tensioning devices. Tighten or loosen as needed to achieve a consistent and appropriate level of tautness across all cables in the system. Aim for a tension that provides a solid feel without causing undue stress on the posts. Refer to manufacturer recommendations or local building codes for specific tensioning guidelines if available.
Every video in How to Tension and Adjust Stair Cable Railing
Step 1: Initial Cable Engagement
- 0:06–0:26 Thread and Cut Cables
- 3:19–4:10 Thread Cable Railing
- 0:10–0:20 Uncoiling and Initial Cable Threading
Step 2: Attach Tensioning Fitting to First Cable End
- 8:20–9:15 Swage Cable onto Fittings
- 5:01–6:53 Thread and Terminate Tensioning Cable Ends
- 0:26–0:41 Secure and Tension Cables
Step 3: Install Tensioning Device at Opposite End
- 0:53–0:59 Install Tensioning Terminal
- 0:25–0:35 Attaching and Initial Tightening of Tensioning Terminals
- 8:35–9:31 Tighten Cable Tensioners
Step 4: Initial Cable Tensioning
- 1:06–1:30 Tension Cables
- 1:00–1:09 Hand-Tighten and Seat Cables
- 9:02–11:37 Tension the Cables
Step 5: Check for Sag and Vibration
- 0:29–0:46 Tension the Cables
- 1:06–1:30 Tension Cables
- 1:00–1:09 Hand-Tighten and Seat Cables
Step 6: Fine-Tuning Tension
- 0:29–0:46 Tension the Cables
- 12:30–13:00 Tension Cable Lines
- 1:09–1:18 Final Cable Tensioning (this video)
Step 7: Secure Tensioning Device
- 12:30–13:00 Tension Cable Lines
- 6:42–7:06 Final Cable Tensioning
- 1:06–1:30 Tension Cables
Step 8: Final Inspection and Trim Excess Cable
- 10:36–10:55 Trim Excess Cable & Install End Caps
- 1:30–1:40 Final Inspection and Completion
- 1:09–1:18 Final Cable Tensioning
How to Tension and Adjust Stair Cable Railing
This project outlines the steps to properly tension and adjust a cable railing system on a staircase, ensuring safety and a clean aesthetic.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

