Hand-Tighten and Seat Cables
From How to Tension and Adjust Stair Cable Railing · Step 4 of 8 · Video by Fine Homebuilding

Showing 1:00–1:09 of the source video. Watch the full video with every moment.
What happens in this clip
Once the cable is installed at both ends, hand-tighten the adjustable tensioning hardware to take up any initial slack in the cable. After hand-tightening, give the cable a firm tap with the palm of your hand. This action helps to ensure that the cable is fully and securely seated within both the adjustable and non-adjustable hardware components, preventing any future slippage or looseness.
Goal: Remove initial slack and ensure proper seating of the cable.
About the full video
This project provides a concise overview of installing cable railing on stairs. It covers essential layout considerations, including code-compliant spacing, proper hardware installation techniques, cable cutting and seating, and the final tensioning process to achieve a secure and aesthetically pleasing railing system.
Step 4 of 8: Initial Cable Tensioning
Using the installed tensioning device (turnbuckle or nuts on the threaded rod), begin to apply tension to the cable. Gradually tighten the device, observing the cable's tautness. The goal is to remove significant slack, making the cable firm to the touch without causing excessive deflection or stress on the posts. Aim for a slight give when pressed, indicating adequate tension without over-tightening.
Every video in How to Tension and Adjust Stair Cable Railing
Step 1: Initial Cable Engagement
- 0:06–0:26 Thread and Cut Cables
- 3:19–4:10 Thread Cable Railing
- 0:10–0:20 Uncoiling and Initial Cable Threading
Step 2: Attach Tensioning Fitting to First Cable End
- 8:20–9:15 Swage Cable onto Fittings
- 5:01–6:53 Thread and Terminate Tensioning Cable Ends
- 0:26–0:41 Secure and Tension Cables
Step 3: Install Tensioning Device at Opposite End
- 0:53–0:59 Install Tensioning Terminal
- 0:25–0:35 Attaching and Initial Tightening of Tensioning Terminals
- 8:35–9:31 Tighten Cable Tensioners
Step 4: Initial Cable Tensioning
- 1:06–1:30 Tension Cables
- 1:00–1:09 Hand-Tighten and Seat Cables (this video)
- 9:02–11:37 Tension the Cables
Step 5: Check for Sag and Vibration
- 0:29–0:46 Tension the Cables
- 1:06–1:30 Tension Cables
- 1:00–1:09 Hand-Tighten and Seat Cables
Step 6: Fine-Tuning Tension
- 0:29–0:46 Tension the Cables
- 12:30–13:00 Tension Cable Lines
- 1:09–1:18 Final Cable Tensioning
Step 7: Secure Tensioning Device
- 12:30–13:00 Tension Cable Lines
- 6:42–7:06 Final Cable Tensioning
- 1:06–1:30 Tension Cables
Step 8: Final Inspection and Trim Excess Cable
- 10:36–10:55 Trim Excess Cable & Install End Caps
- 1:30–1:40 Final Inspection and Completion
- 1:09–1:18 Final Cable Tensioning
How to Tension and Adjust Stair Cable Railing
This project outlines the steps to properly tension and adjust a cable railing system on a staircase, ensuring safety and a clean aesthetic.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

