Lay Out Stringers
From How to Lay Out Winder Stairs · Step 4 of 7 · Video by The BC Builder

Showing 4:54–6:32 of the source video. Watch the full video with every moment.
What happens in this clip
With the framing square set to your calculated unit rise and unit run (and adjusted for the bottom tread thickness), position the square on your wooden stringer board. Align the marks on the square with the edge of the board. Draw the first step's triangle onto the board using a marker or pencil. Then, slide the framing square down the board, aligning the previous step's mark with the next measurement point on the square, and draw the next step's triangle. Repeat this process for all remaining steps until the entire stringer is laid out. Remember that local building codes dictate minimum 'throat distance' (the remaining material after cuts) for structural integrity, so typically 2x12 lumber is used for stringers to ensure sufficient material remains.
Goal: Transfer the calculated rise and run measurements onto the wooden stringer board.
What's used
Tools
- Framing Square Unknown (rusty appearance in video)
- Marker
- Chalk line
Materials
- Stringer Board
About the full video
This project provides a comprehensive guide on calculating and building a simple set of stairs. It covers the essential mathematics behind determining unit rise and run, understanding crucial adjustments for tread thickness, and the practical application of a framing square for laying out stringers. The video concludes with instructions on cutting and assembling the stair components.
Step 4 of 7: Layout the Stair Angle and Width
Mark the start and end points of the staircase run on the subfloor. Use the total run and total rise measurements to determine the length of the stringer by applying the Pythagorean theorem (a² + b² = c²). Alternatively, use a framing square to lay out the pitch line. Mark the desired width of the stairs on the subfloor, ensuring it meets code requirements and accommodates the stringers and treads.
Every video in How to Lay Out Winder Stairs
Step 1: Determine Total Rise and Run
- 2:54–4:34 Determine the Total Rise
- 0:16–1:17 Measure and Calculate Total Rise
- 0:04–0:30 Measure Total Rise
Step 2: Calculate Number of Treads and Risers
- 2:59–6:51 Calculate Number of Risers and Treads
- 8:59–9:54 Calculate Number of Risers and Treads
- 0:32–0:54 Calculate Number of Risers
Step 3: Determine Tread Depth and Landing Dimensions
Step 4: Layout the Stair Angle and Width
- 4:54–6:32 Lay Out Stringers (this video)
- 6:42–8:10 Lay Out the Stringer Using a Framing Square
- 0:11–1:48 Calculate and Layout Staircase Dimensions
Step 5: Determine Winder Tread Layout
Step 6: Mark Stringers for Winder Treads
- 6:54–8:50 Marking Stringers
- 0:59–1:13 Mark First Step Cuts
- 1:28–2:15 Implement the Nosing Offset Adjustment
Step 7: Cut Stringers
- 9:35–10:04 Cut the Stringer
- 15:28–20:38 Cut Stringers
- 0:42–0:53 Cut the Stringers
How to Lay Out Winder Stairs
This project outlines the process for accurately laying out winder stairs, which feature wedge-shaped treads that turn a corner. The process involves careful measurement, mathematical calculations, and precise marking to ensure safety, code compliance, and aesthetic appeal.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

