Cut the Stringer
From How to Lay Out Winder Stairs · Step 7 of 7 · Video by Training Hands Academy

Showing 9:35–10:04 of the source video. Watch the full video with every moment.
What happens in this clip
When it comes to cutting the stringers, take your time and be precise. Use a circular saw for the majority of the cuts along the marked lines for the treads and risers. Ensure the saw's shoe is flat on the lumber before making each cut. It's important not to overcut the lines into the corners, as this can weaken the stringer. For the tight internal corners where the circular saw blade cannot reach, use a handsaw to finish the cuts. The last thing to note is that it's best to leave no less than 3.5 inches (89 millimeters) of material in the narrowest part of the stringer (the 'throat' area between the cuts) to maintain structural integrity. Going any thinner than that can significantly weaken the stringer.
Goal: Precisely cut the marked step pattern into the lumber
What's used
Tools
- Circular Saw Makita
- Handsaw
About the full video
This project provides a detailed guide on how to figure out the dimensions, lay out, and cut stair stringers for a basic set of stairs. It covers essential terminology, mathematical calculations for total rise, total run, unit rise, and unit run, as well as considerations for attachment methods and tread thickness. The instructions culminate in the marking and cutting of a wooden stringer using a framing square, circular saw, and hand saw.
Step 7 of 7: Cut Stringers
Using a circular saw or handsaw, carefully cut along all the marked lines on the stringers. Make precise cuts for the tread notches and riser lines. Pay special attention to the angled cuts required for the winder sections to ensure they align perfectly with the winder tread layout. Ensure all cuts are clean and accurate for a tight fit.
Every video in How to Lay Out Winder Stairs
Step 1: Determine Total Rise and Run
- 2:54–4:34 Determine the Total Rise
- 0:16–1:17 Measure and Calculate Total Rise
- 0:04–0:30 Measure Total Rise
Step 2: Calculate Number of Treads and Risers
- 2:59–6:51 Calculate Number of Risers and Treads
- 8:59–9:54 Calculate Number of Risers and Treads
- 0:32–0:54 Calculate Number of Risers
Step 3: Determine Tread Depth and Landing Dimensions
Step 4: Layout the Stair Angle and Width
- 4:54–6:32 Lay Out Stringers
- 6:42–8:10 Lay Out the Stringer Using a Framing Square
- 0:11–1:48 Calculate and Layout Staircase Dimensions
Step 5: Determine Winder Tread Layout
Step 6: Mark Stringers for Winder Treads
- 6:54–8:50 Marking Stringers
- 0:59–1:13 Mark First Step Cuts
- 1:28–2:15 Implement the Nosing Offset Adjustment
Step 7: Cut Stringers
- 9:35–10:04 Cut the Stringer (this video)
- 15:28–20:38 Cut Stringers
- 0:42–0:53 Cut the Stringers
How to Lay Out Winder Stairs
This project outlines the process for accurately laying out winder stairs, which feature wedge-shaped treads that turn a corner. The process involves careful measurement, mathematical calculations, and precise marking to ensure safety, code compliance, and aesthetic appeal.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

