Determine Tread Overhang and Length
From How to Lay Out Winder Stairs · Step 3 of 7 · Video by The Excellent Laborer

Showing 5:03–6:09 of the source video. Watch the full video with every moment.
What happens in this clip
Determine the exact dimensions of the treads, considering a minimum run of 10 inches and an acceptable overhang (e.g., 3/4 inch to 1 1/4 inches). If using 2x12 lumber for treads (actual width typically 11 1/4 inches), a 10 1/4 inch run will allow for a 3/4 inch overhang. This overhang, often called the nosing, adds to comfort and aesthetics. Note that the riser board thickness is factored into the total run.
Goal: Establish tread dimensions including nosing.
What's used
Tools
- 2x12 Lumber
- Laminated veneer lumber (LVL)
- Tape Measure Milwaukee
About the full video
This project provides a detailed guide on how to build L-shaped stairs with a landing, from calculating rise and run based on local building codes and flooring thickness, to cutting stringers, framing the landing, and installing risers and treads. The instructions emphasize precision in measurements and adherence to safety and comfort standards for stair construction.
Step 3 of 7: Determine Tread Depth and Landing Dimensions
Using the total run available and the number of treads, calculate the nominal tread depth. Ensure this depth, when combined with the riser height, meets the '2R + T' rule (twice the rise plus the tread depth should be between 24 and 25 inches) for comfortable and safe walking. If a landing is required, ensure its dimensions meet code (typically at least as wide as the stair and as deep as the stair's run).
Every video in How to Lay Out Winder Stairs
Step 1: Determine Total Rise and Run
- 2:54–4:34 Determine the Total Rise
- 0:16–1:17 Measure and Calculate Total Rise
- 0:04–0:30 Measure Total Rise
Step 2: Calculate Number of Treads and Risers
- 2:59–6:51 Calculate Number of Risers and Treads
- 8:59–9:54 Calculate Number of Risers and Treads
- 0:32–0:54 Calculate Number of Risers
Step 3: Determine Tread Depth and Landing Dimensions
- 2:05–2:24 Calculate Individual Riser Height & Tread Depth
- 5:03–6:09 Determine Tread Overhang and Length (this video)
- 3:14–4:28 Minimum Tread Depth and Landing Dimensions
Step 4: Layout the Stair Angle and Width
- 4:54–6:32 Lay Out Stringers
- 6:42–8:10 Lay Out the Stringer Using a Framing Square
- 0:11–1:48 Calculate and Layout Staircase Dimensions
Step 5: Determine Winder Tread Layout
Step 6: Mark Stringers for Winder Treads
- 6:54–8:50 Marking Stringers
- 0:59–1:13 Mark First Step Cuts
- 1:28–2:15 Implement the Nosing Offset Adjustment
Step 7: Cut Stringers
- 9:35–10:04 Cut the Stringer
- 15:28–20:38 Cut Stringers
- 0:42–0:53 Cut the Stringers
How to Lay Out Winder Stairs
This project outlines the process for accurately laying out winder stairs, which feature wedge-shaped treads that turn a corner. The process involves careful measurement, mathematical calculations, and precise marking to ensure safety, code compliance, and aesthetic appeal.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

