Gluing and Fastening the Return Piece
From How to Install a Handrail Return at the End of a Rail · Step 4 of 6 · Video by ArtisanTony

Showing 4:26–5:07 of the source video. Watch the full video with every moment.
What happens in this clip
After pre-drilling, apply wood glue to the mating surface of the handrail return piece. Align the pre-drilled return piece with the main handrail, ensuring the slight overhang as previously described. Then, use a cordless impact driver to secure the return piece with a screw. As the screw tightens, the return piece will slide into a perfectly flush position, eliminating the overhang. Immediately wipe away any excess glue that squeezes out to prevent it from drying and creating a messy surface that is difficult to sand or stain later. Finally, ensure the screw head is countersunk so it sits flush or slightly below the surface, ready for wood filler and finishing.
Goal: Securely and permanently attach the return piece to the handrail.
What's used
Tools
- Cordless Impact Driver Milwaukee
- Screwdriver
- Driver Bit
- Handrail Return Piece
- Main Handrail
- Rag
- Sponge
- Wood Glue
- permanent bond between the handrail pieces.
About the full video
This project details the process of cutting, preparing, and securely attaching return pieces to a handrail, emphasizing code compliance for wall clearance, optimal bracket selection, and precise assembly techniques. It covers pre-drilling, gluing, and fastening the return piece to the main handrail, along with tips for preparing the wood for a finish.
Step 4 of 6: Secure Handrail Return to Handrail
Apply wood glue or a suitable adhesive to the joint between the handrail and the return. For added strength, insert dowels or screws through pre-drilled holes. Clamp the pieces together firmly until the adhesive sets.
Every video in How to Install a Handrail Return at the End of a Rail
Step 1: Mark Handrail Return Position
Step 2: Prepare Handrail End for Return
- 2:44–3:32 Cut Handrail Ends for Returns
- 4:05–5:23 Cut Handrail for Returns
- 2:44–3:21 Cut Handrail Ends with Miter Saw
Step 3: Fit and Test Handrail Return
- 4:24–5:10 Final Handrail Installation and Stability Check
- 5:43–5:52 Dry Fit Handrail over Balusters
- 5:22–5:43 Shape Handrail Return Ends
Step 4: Secure Handrail Return to Handrail
- 4:26–5:07 Gluing and Fastening the Return Piece (this video)
- 9:58–10:29 Fabricate and Install Handrail Return
- 3:32–4:24 Assemble Handrail End Returns
Step 5: Mount Handrail Assembly to Wall/Newel Post
- 0:54–1:00 Connect Handrail to Newel Post
- 12:33–14:45 Install Handrail to Newel Post and Wall
- 0:15–0:22 Attach Handrail to Newel Post
Step 6: Finish and Inspect
- 1:53–2:04 Final Sanding and Cleaning
- 0:28–0:36 Finishing and Sealing
- 0:43–0:46 Finishing Touches (Sanding, Finishing, Caulk)
How to Install a Handrail Return at the End of a Rail
This project outlines the steps to properly install a handrail return, which is the curved or angled section at the end of a handrail that transitions it back to the wall or newel post. This ensures a safe and aesthetically pleasing finish.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

