Cut Handrail Ends for Returns
From How to Install a Handrail Return at the End of a Rail · Step 2 of 6 · Video by normalguydiy

Showing 2:44–3:32 of the source video. Watch the full video with every moment.
What happens in this clip
Since the handrail is longer than needed (e.g., 8-foot stock for a 7-foot run), you will need to cut it to size and create aesthetic 'returns' at each end. These returns are small sections that turn the handrail back towards the wall, preventing clothing from snagging and providing a finished look. Use a miter saw to cut a 45-degree angle on each end of your main handrail section. From the leftover handrail material, cut two separate, short pieces, also with 45-degree angles, to serve as the return sections.
Goal: Create angled cuts on the handrail and separate return pieces for a finished look.
What's used
Tools
- Handrail stock
- Miter Saw Kobalt
- Safety Glasses
About the full video
This DIY project provides step-by-step instructions for installing a simple handrail on a stairway. It covers determining the correct height, securely mounting brackets into wall studs, cutting and assembling handrail end returns, and finally attaching and checking the stability of the handrail.
Step 2 of 6: Prepare Handrail End for Return
Depending on the type of return (e.g., volute, easing, or a simple angle), you may need to cut the existing handrail end to a specific angle or shape. This often involves using a miter saw or coping saw to create a clean joint. For some returns, a specific fitting may require a pre-cut notch or end profile.
Every video in How to Install a Handrail Return at the End of a Rail
Step 1: Mark Handrail Return Position
Step 2: Prepare Handrail End for Return
- 2:44–3:32 Cut Handrail Ends for Returns (this video)
- 4:05–5:23 Cut Handrail for Returns
- 2:44–3:21 Cut Handrail Ends with Miter Saw
Step 3: Fit and Test Handrail Return
- 4:24–5:10 Final Handrail Installation and Stability Check
- 5:43–5:52 Dry Fit Handrail over Balusters
- 5:22–5:43 Shape Handrail Return Ends
Step 4: Secure Handrail Return to Handrail
- 4:26–5:07 Gluing and Fastening the Return Piece
- 9:58–10:29 Fabricate and Install Handrail Return
- 3:32–4:24 Assemble Handrail End Returns
Step 5: Mount Handrail Assembly to Wall/Newel Post
- 0:54–1:00 Connect Handrail to Newel Post
- 12:33–14:45 Install Handrail to Newel Post and Wall
- 0:15–0:22 Attach Handrail to Newel Post
Step 6: Finish and Inspect
- 1:53–2:04 Final Sanding and Cleaning
- 0:28–0:36 Finishing and Sealing
- 0:43–0:46 Finishing Touches (Sanding, Finishing, Caulk)
How to Install a Handrail Return at the End of a Rail
This project outlines the steps to properly install a handrail return, which is the curved or angled section at the end of a handrail that transitions it back to the wall or newel post. This ensures a safe and aesthetically pleasing finish.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

