Measure Handrail Height
From How to Find Studs and Set the Right Handrail Height · Step 1 of 5 · Video by Stair Supplies

Showing 0:40–1:07 of the source video. Watch the full video with every moment.
What happens in this clip
Begin by determining the appropriate height for your handrail. This is typically dictated by local building codes, so ensure you consult them. Measure straight up from the front of the nosing (the edge of the step) on both the first and the last step where the handrail will begin and end. In this video, a height of 36 inches is used as an example. Mark these two locations on the wall with a Sharpie or pencil.
Goal: Determine and mark the appropriate handrail height
What's used
Tools
- Sharpie or Pencil
- Tape Measure
About the full video
This project guides you through the process of installing wall-mounted handrail brackets and then securely attaching a handrail to them. It covers measuring for proper height, accurately marking bracket placements, ensuring structural backing, and finally mounting both the brackets and the handrail itself.
Step 1 of 5: Determine Handrail Height
Using a tape measure, locate the desired height for the handrail. A common standard is to place the top of the handrail 34 inches above the slope or nosing of the stair. Measure this height at several points along the staircase to ensure consistency. Mark these points lightly with a pencil.
Every video in How to Find Studs and Set the Right Handrail Height
Step 1: Determine Handrail Height
- 0:47–1:58 Mark Handrail Height
- 0:40–1:07 Measure Handrail Height (this video)
- 3:48–4:29 Verify Handrail Height for Code Compliance
Step 2: Locate Wall Studs
- 3:11–4:40 Utilize an Electronic Stud Finder and Mount Item
- 0:34–1:16 Locate and Mark Studs with Stud Finder
- 0:04–0:13 Locate Wall Studs
Step 3: Mark Support Bracket Locations
- 1:25–2:44 Install Handrail Brackets (Wood Studs)
- 2:22–2:54 Mark Screw Locations
- 2:46–3:44 Locate and Mark Studs for Brackets
Step 4: Drill Pilot Holes
- 1:47–2:15 Locate Studs and Drill Pilot Holes
- 0:31–0:38 Drill Pilot Holes
- 8:51–9:40 Pre-Drill Pilot Holes
Step 5: Attach Support Brackets
- 0:23–0:35 Install Handrail Brackets
- 2:28–2:44 Install Brackets and Mount Handrail
- 2:15–2:28 Mount Handrail Brackets
How to Find Studs and Set the Right Handrail Height
This project outlines the steps to locate wall studs and determine the correct height for installing a handrail, ensuring safety and code compliance for stairways and accessible routes.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

