Pre-Drill Pilot Holes
From How to Find Studs and Set the Right Handrail Height · Step 4 of 5 · Video by Handyman Startup

Showing 8:51–9:40 of the source video. Watch the full video with every moment.
What happens in this clip
Using the previously marked pilot hole locations (on the studs), take your drill and the appropriate 3/16 inch or 7/32 inch drill bit. Carefully pre-drill a pilot hole at each marked location. It's crucial to use a drill bit that is slightly smaller than the lag screws you will be using. This allows the lag screws to tightly grip the wood of the studs, ensuring a secure mount. Before drilling, check the other side of the wall for any obstructions or electrical wires. If an electrical wire is present, it should ideally be protected by a metal plate behind the drywall.
Goal: Create pilot holes for the lag screws in the wall studs
What's used
Tools
- 3/16 inch or 7/32 inch Wood or Metal Drill Bit
- Drill DeWalt
About the full video
This DIY project guides you through the process of securely wall mounting your television. It covers everything from gathering the necessary tools and preparing the TV brackets to accurately measuring and marking the wall, locating studs, pre-drilling pilot holes, attaching the wall mount, and finally hanging the TV. The instructions also include crucial tips on ensuring the TV is level and avoiding common mistakes like using the wrong screws.
Step 4 of 5: Drill Pilot Holes
Select a drill bit that is slightly smaller than the diameter of the screws you will be using for the brackets. At each marked screw location, drill a pilot hole into the center of the wall stud. Drill to a depth sufficient for the screw to engage the stud securely.
Every video in How to Find Studs and Set the Right Handrail Height
Step 1: Determine Handrail Height
- 0:47–1:58 Mark Handrail Height
- 0:40–1:07 Measure Handrail Height
- 3:48–4:29 Verify Handrail Height for Code Compliance
Step 2: Locate Wall Studs
- 3:11–4:40 Utilize an Electronic Stud Finder and Mount Item
- 0:34–1:16 Locate and Mark Studs with Stud Finder
- 0:04–0:13 Locate Wall Studs
Step 3: Mark Support Bracket Locations
- 1:25–2:44 Install Handrail Brackets (Wood Studs)
- 2:22–2:54 Mark Screw Locations
- 2:46–3:44 Locate and Mark Studs for Brackets
Step 4: Drill Pilot Holes
- 1:47–2:15 Locate Studs and Drill Pilot Holes
- 0:31–0:38 Drill Pilot Holes
- 8:51–9:40 Pre-Drill Pilot Holes (this video)
Step 5: Attach Support Brackets
- 0:23–0:35 Install Handrail Brackets
- 2:28–2:44 Install Brackets and Mount Handrail
- 2:15–2:28 Mount Handrail Brackets
How to Find Studs and Set the Right Handrail Height
This project outlines the steps to locate wall studs and determine the correct height for installing a handrail, ensuring safety and code compliance for stairways and accessible routes.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

